Britax Child Seat manual How to Adjust Harness Slot Height, Fastening the Harness Buckle

Page 17

Child Seat Functions

Child Seat Functions

Harness Buckle

Fastening the Harness Buckle

1Hold the harness buckle with one hand.

2Use the other hand to insert one buckle tongue at a time into the harness buckle (Fig. A).

•A proper connection is confirmed with a positive click after inserting each buckle tongue.

Releasing the Harness Buckle

1Brace the rear of the harness buckle with one hand.

2Use your thumb to press the release button and slide both buckle tongues to remove from the buckle (Fig. B).

a x2

b

How to Adjust Harness Slot Height

IMPORTANT: See Important Harness Adjustments on pages 6 – 7 for important instructions on proper harness fit based on your child’s height and weight.

1Loosen the harness by pressing the harness- adjuster release button while pulling the harness c straps forward as far as possible (Fig. C).

2From the rear of the child seat, unhook the harness straps from the harness yoke (Fig. D).

3Pull upper harness straps through the shell, foam, and cover to the front of the child seat.

4Thread the harness straps through the appropriate harness slots in the cover, foam, and child seat dshell (Fig. E).

5 Reattach harness straps to the harness yoke (Fig.

D).

IMPORTANT: Periodically clean the harness buckle to ensure safe operation. See page 36.

6	Pull harness adjuster strap to tighten the harness.
7	Verify all harness straps are threaded at the same
	height and are not twisted.


	Securing Your Child			e
	1	Loosen the harness by pressing the harness adjuster		e
	1	Loosen the harness by pressing the harness adjuster
		release button located on the front of the child
		seat, then pull the harness straps forward (Fig. C).
	2	Release the chest clip by squeezing the tabs and
		sliding pieces apart (Fig. F).
	3	Unfasten the harness buckle by pressing the release
		button and sliding the tongues out.		f
	4	Move the harness straps to the side of the child		f
		seat.

• Use the harness holder located on the straps and side of the cover to aid in holding the straps.

5 Place child in the child seat.

30

31

Image 17

Contents Roundabout Table of Contents Secure the top tether strap provided with this child seat Registration Important NotesCertification Inches When the top of the child’s ears are below the top Important Harness AdjustmentsForward-Facing Rear-FacingChild Seat Features See diagram below Vehicle Safety BeltsVehicle Buckle Positions Vehicle Seating PositionsIntended Lower Universal Anchorage System Luas InstallationIf stored, remove the LCS strap and connectors Vehicle belt can be routed over or under the cover Lap-Shoulder Belt InstallationPosition the lap belt portion through the open Has and how to lock the retractor Lap-Belt InstallationLock-off is properly closed when a positive click is heard Car is parked on a level surface Fig. FWho weigh less than 9.1 kg 20 lbs This child seat must not be used forwardLocations Under the cover. See page 28. Pull both LCSAForward-facing Lap-Belt Installation Forward-Facing Installation Safety InformationRear-Facing Installation Tether Connector Strap Using the Versa-TetherRecline Adjustment Switching the Lower Connector System LCSStoring the LCS Connectors Chest ClipHarness Buckle How to Adjust Harness Slot HeightFastening the Harness Buckle Releasing the Harness BuckleChild Seat Cover Removal Child Seat Functions Care and MaintenanceRe-threading the Harness Buckle Harness Buckle RemovalWarranty Cleaning the Harness BuckleInstallation sangle Versa-Tether Mise EN GARDE Enregistrement Remarques importantesHomologation Siège orienté face à larrière Important réglage du harnaisFace à lavant Qui sont âgés dau moins un an etSous la housse Ceintures de sécurité du véhicule Voir le diagramme ci-dessousPositions de la boucle de ceinture du Véhicule Positions assises du véhiculeInstallation avec système dancrage universel au bas Luas Lorsque les connecteurs Luas ne sont pas utilisés, toujours Installation avec ceinture à trois points dappuiDauto.sur une surface horizontale figure F.90º Installation avec ceinture sous-abdominaleSi nécessaire, on peut obtenir le bon angle dinclinaison f Est faite correctement Remarque Si lon nentend pas un déclic positif mais que leCoquille LarrièreJeu de la sangle dattache pour obtenir une fixation Face à lavant avec ceinture à trois points dappuiVerrouiller le rétracteur Mise EN Garde Consignes de sécurité Installation dans un avionInstallation du siège orienté face à lavant Utilisation de la sangle Versa-Tether Sangle de connexion dattacheRepérez un point d’ancrage fixe qui soit Sur la sangle dattacheRemarque Les sièges dauto sont livrés par Britax avec Interversion du système à connecteur bas LCSRangement des connecteurs LCS Boucle pour les retirer de la boucle figure B Boucle du harnaisTenir la boucle du harnais avec une main Retirerdoucementlapartiesupérieuredelahousse. f Retrait de la housse du siège dautoDauto De poitrine par les fentes inférieures dans la housseNettoyer À Léponge avec de leau tiède et un savon doux Retrait de la boucle du harnaisPassage de la boucle du harnais Garantie Nettoyage de la boucle du harnaisIMPORTANT