Britax Child Seat manual Vehicle Safety Belts, Vehicle Buckle Positions, Vehicle Seating Positions

Page 7

Vehicle Compatibility

Vehicle Safety Belts

NOTE : The information in this section only applies to installation with vehicle safety belts.

IMPORTANT: Vehicle seats and safety belts differ from vehicle to vehicle. Refer to your vehicle owner’s manual for specific information about vehicle safety belts and their use with child seats. Some vehicles have no seating positions which are compatible with this child seat or any other child seat. If in doubt, contact the vehicle manufacturer for assistance.

This child seat can fit securely in most vehicles using existing vehicle belts. However, some vehicle designs prevent a secure fit of the child seat.

The vehicle owner’s manual will have information on the types of vehicle belts in your vehicle. If your belt type is listed below, select another seating position or use the Lower Universal Anchorage System (LUAS).

WARNING! The following types of vehicle belts are not compatible with this child seat :

Front vehicle belts with top or bottom anchorage

points in the door. (Fig. A & B)

Motor-driven, automatic vehicle belts. (Fig. B)

A

Lap-shoulder belts that have separate retractors

 

for shoulder section and lap section in which lap

 

section retractor does not lock.

 

 

Non-locking,

two-point

Emergency

Locking

 

Retractor (ELR) vehicle belts.

 

 

Lap-shoulder ELR vehicle belts without use of the

b

lock-off.

 

 

 

NOTE : Refer to your vehicle owner’s manual to determine the kind of retractors used in your vehicle and how to operate them.

Vehicle Compatibility

Vehicle Buckle Positions

WARNING! The position of the vehicle belt buckle can adversely affect the stability of the

child seat.

If the buckle lies near the position marked wrong ( ) when the vehicle belt is tightened,

try fitting the child seat in another seating

position in the vehicle OR consult your vehicle owner’s manual to see if you can lower the vehicle buckle position by twisting the vehicle buckle stalk. If it is not possible to achieve the correct position () for the buckle, then another seating position

MUST be used.

Vehicle Seating Positions

WARNING! Forward-facing vehicle seats MUST be used with this child seat. Side-facing or rear-facing seats CANNOT be used.

See diagram below.

WARNING!

DO NOT place a child seat rear-facing in the front seat of a vehicle with a passenger air bag unless deactivated. DEATH or SERIOUS INJURY can occur. See your vehicle

owner's manual for child seat installation instruc- tions. The back seat is the safest place for children 12

and under.

10

11

Image 7
Contents Roundabout Table of Contents Secure the top tether strap provided with this child seat Certification Important NotesRegistration Rear-Facing Important Harness AdjustmentsInches When the top of the child’s ears are below the top Forward-FacingChild Seat Features Vehicle Seating Positions Vehicle Safety BeltsSee diagram below Vehicle Buckle PositionsIf stored, remove the LCS strap and connectors Lower Universal Anchorage System Luas InstallationIntended Position the lap belt portion through the open Lap-Shoulder Belt InstallationVehicle belt can be routed over or under the cover Car is parked on a level surface Fig. F Lap-Belt InstallationHas and how to lock the retractor Lock-off is properly closed when a positive click is heardUnder the cover. See page 28. Pull both LCS This child seat must not be used forwardWho weigh less than 9.1 kg 20 lbs LocationsAForward-facing Lap-Belt Installation Rear-Facing Installation Safety InformationForward-Facing Installation Tether Connector Strap Using the Versa-TetherChest Clip Switching the Lower Connector System LCSRecline Adjustment Storing the LCS ConnectorsReleasing the Harness Buckle How to Adjust Harness Slot HeightHarness Buckle Fastening the Harness BuckleChild Seat Cover Removal Child Seat Functions Care and MaintenanceRe-threading the Harness Buckle Harness Buckle RemovalWarranty Cleaning the Harness BuckleInstallation sangle Versa-Tether Mise EN GARDE  Homologation Remarques importantesEnregistrement Qui sont âgés dau moins un an et Important réglage du harnaisSiège orienté face à larrière Face à lavantSous la housse Positions assises du véhicule Voir le diagramme ci-dessousCeintures de sécurité du véhicule Positions de la boucle de ceinture du VéhiculeInstallation avec système dancrage universel au bas Luas Lorsque les connecteurs Luas ne sont pas utilisés, toujours Installation avec ceinture à trois points dappuiSi nécessaire, on peut obtenir le bon angle dinclinaison f Installation avec ceinture sous-abdominaleDauto.sur une surface horizontale figure F.90º Larrière Remarque Si lon nentend pas un déclic positif mais que leEst faite correctement CoquilleVerrouiller le rétracteur Face à lavant avec ceinture à trois points dappuiJeu de la sangle dattache pour obtenir une fixation Mise EN Garde Installation du siège orienté face à lavant Installation dans un avionConsignes de sécurité Sur la sangle dattache Sangle de connexion dattacheUtilisation de la sangle Versa-Tether Repérez un point d’ancrage fixe qui soitRangement des connecteurs LCS Interversion du système à connecteur bas LCSRemarque Les sièges dauto sont livrés par Britax avec Tenir la boucle du harnais avec une main Boucle du harnaisBoucle pour les retirer de la boucle figure B De poitrine par les fentes inférieures dans la housse Retrait de la housse du siège dautoRetirerdoucementlapartiesupérieuredelahousse. f DautoPassage de la boucle du harnais Retrait de la boucle du harnaisNettoyer À Léponge avec de leau tiède et un savon doux Garantie Nettoyage de la boucle du harnaisIMPORTANT