Britax Child Seat manual Lower Universal Anchorage System Luas Installation, Intended

Page 8

Installation : Rear-facing

Lower Universal Anchorage System (LUAS) Installation

Figure A illustrates a typical rear-facing LUAS installation.

Verify that your vehicle is equipped with LUAS anchors.

If LUAS anchors are not available, you must use vehicle

belt installation methods.

 

1 If stored, remove the LCS strap and connectors

 

from the storage slots under the cover. See

A Rear-facing

page 28.

 

2Press and hold one LCS adjuster release button, then pull to extend LCS strap to full length. Repeat on the other end of the strap

IMPORTANT:

Check that the LCS connector strap is tight and not

 

twisted, and that the LCS connectors are in an upright

b

 

 

position (Fig. C) to ensure proper installation.

 

The LCS strap must rest behind the child seat buckle

 

 

Release

Top

 

strap.

Button

3

Thread each LCS connector through the

 

 

adjacent rear-facing belt slot (Fig. B).

 

 

4Fully recline the child seat and place it sideways on the vehicle seat with the front facing toward

you.c

WARNING! This child seat must be in the recline position when installed rear-facing. See

Recline Adjustment on page 29.

5Verify that the LCS straps are not twisted and attach the closest LCS connector to the vehicle

seat to the farthest LUAS anchor (Fig. D).

d

6 Rotate the child seat into the rear-facing

position.

Installation : Rear-facing

7Verify that the LCS strap is not twisted and attach the remaining LCS connector to the adjacent LUAS anchor (Fig. E).

NOTE : It may be necessary to switch the LCS connectors as shown on page 28 if ANY of the

following conditions exist :

e

• LCS connector is not in an upright position (Fig. C).

LCS strap is twisted.

A positive click is NOT heard when the LCS connector connects to the LUAS anchor.

NOTE : If a positive click is not heard, but the LCS

 

 

 

connector is in an upright position, you should not

 

 

 

switch the LCS connectors. The strap may be too

 

 

 

tight or twisted, or there may be debris in the LCS

f

 

 

connector.

 

 

8

Push the child seat firmly into the vehicle

 

 

 

 

seat while pulling the LCS adjuster strap tight

30–45º

 

 

 

 

 

(Fig. F).

 

 

 

9

Verify all connections are secure and that the

 

 

 

 

child seat is stable.

 

 

 

The child seat is secure when it cannot be moved

 

90º

 

more than 2.5 cm (1 inch) front-to-back or side-to-

g

 

 

 

 

side at the belt path. If the child seat is not secure,

 

 

 

 

 

 

repeat the procedure or use an alternate seating location.

When properly installed in the rear-facing position, the back angle of the child seat should be 30º – 45º from vertical (not to exceed 45º) when the car is parked on a level surface (Fig. G).

If necessary, the proper recline angle can be achieved by placing a rolled towel or pool noodle in the crease of the vehicle seat to level the child seat’s base.

WARNING! Do not raise the child seat off the front edge of the vehicle seat. This could cause your child seat not to perform as

intended.

Rear-facing installation can be improved by the use of the Versa-Tether. See pages 25 – 27.

12

13

Image 8
Contents Roundabout Table of Contents Secure the top tether strap provided with this child seat Registration Important NotesCertification Important Harness Adjustments Inches When the top of the child’s ears are below the topForward-Facing Rear-FacingChild Seat Features Vehicle Safety Belts See diagram belowVehicle Buckle Positions Vehicle Seating PositionsIntended Lower Universal Anchorage System Luas InstallationIf stored, remove the LCS strap and connectors Vehicle belt can be routed over or under the cover Lap-Shoulder Belt InstallationPosition the lap belt portion through the open Lap-Belt Installation Has and how to lock the retractorLock-off is properly closed when a positive click is heard Car is parked on a level surface Fig. FThis child seat must not be used forward Who weigh less than 9.1 kg 20 lbsLocations Under the cover. See page 28. Pull both LCSAForward-facing Lap-Belt Installation Forward-Facing Installation Safety InformationRear-Facing Installation Using the Versa-Tether Tether Connector StrapSwitching the Lower Connector System LCS Recline AdjustmentStoring the LCS Connectors Chest ClipHow to Adjust Harness Slot Height Harness BuckleFastening the Harness Buckle Releasing the Harness BuckleChild Seat Functions Care and Maintenance Child Seat Cover RemovalHarness Buckle Removal Re-threading the Harness BuckleCleaning the Harness Buckle WarrantyInstallation sangle Versa-Tether Mise EN GARDE  Enregistrement Remarques importantesHomologation Important réglage du harnais Siège orienté face à larrièreFace à lavant Qui sont âgés dau moins un an etSous la housse Voir le diagramme ci-dessous Ceintures de sécurité du véhiculePositions de la boucle de ceinture du Véhicule Positions assises du véhiculeInstallation avec système dancrage universel au bas Luas Installation avec ceinture à trois points dappui Lorsque les connecteurs Luas ne sont pas utilisés, toujoursDauto.sur une surface horizontale figure F.90º Installation avec ceinture sous-abdominaleSi nécessaire, on peut obtenir le bon angle dinclinaison f Remarque Si lon nentend pas un déclic positif mais que le Est faite correctementCoquille LarrièreJeu de la sangle dattache pour obtenir une fixation Face à lavant avec ceinture à trois points dappuiVerrouiller le rétracteur Mise EN Garde Consignes de sécurité Installation dans un avionInstallation du siège orienté face à lavant Sangle de connexion dattache Utilisation de la sangle Versa-TetherRepérez un point d’ancrage fixe qui soit Sur la sangle dattacheRemarque Les sièges dauto sont livrés par Britax avec Interversion du système à connecteur bas LCSRangement des connecteurs LCS Boucle pour les retirer de la boucle figure B Boucle du harnaisTenir la boucle du harnais avec une main Retrait de la housse du siège dauto Retirerdoucementlapartiesupérieuredelahousse. fDauto De poitrine par les fentes inférieures dans la housseNettoyer À Léponge avec de leau tiède et un savon doux Retrait de la boucle du harnaisPassage de la boucle du harnais Nettoyage de la boucle du harnais GarantieIMPORTANT