Philips SCD510/00 manual Why does the parent unit beep?

20 ENGLISH

Question	Answer
Why does the LINK light on	The baby unit and the parent unit are out of range of each other. Move
the parent unit flash red?	the parent unit closer to the baby unit.
	The baby unit may be switched off. Switch on the baby unit.

Why does the battery light on the baby unit flash red?

The non-rechargeable batteries of the baby unit are running low. Replace the non-rechargeable batteries or connect the baby unit to an electrical outlet (see chapter ‘Preparing for use’).

Why does the parent unit beep?

Why does the appliance produce a high-pitched noise?

Why don’t I hear a sound/ Why can’t I hear my baby cry?

Why does the parent unit react too quickly to other sounds?

If the parent unit beeps while the LINK light flashes red, the connection with the baby unit is lost. Move the parent unit closer to the baby unit.

If the parent unit beeps and the battery light flashes red, the rechargeable battery pack of the parent unit is running low. Recharge the battery pack.

The baby unit may be switched off. Switch on the baby unit.

The units may be too close to each other. Make sure the parent unit and the baby unit are at least 3 feet/1 meter away from each other.

The volume of the parent unit may be set too high. Decrease the volume of the parent unit.

The volume of the parent unit may be set too low or may be switched off. Increase the volume of the parent unit.

The microphone sensitivity level of the baby unit may be set too low. Increase the microphone sensitivity level with the SENSITIVITY button on the parent unit.

The baby unit and the parent unit may be out of range of each other. Reduce the distance between the units.

The baby unit also picks up other sounds than those of your baby. Move the baby unit closer to the baby (but observe the minimum distance of 3 feet/1 meter).

The microphone sensitivity level of the baby unit may be set too high. Decrease the microphone sensitivity level with the SENSITIVITY button on the parent unit.

Why does the parent unit react slowly to the baby’s crying?

Why do the non- rechargeable batteries of the baby unit run low quickly?

The microphone sensitivity level of the baby unit may be set too low. Increase the microphone sensitivity level with the SENSITIVITY button on the parent unit.

The microphone sensitivity level of the baby unit may be set too high, which causes the baby unit to transmit more often. Decrease the microphone sensitivity level with the SENSITIVITY button on the parent unit.

The volume on the baby unit may be set too high, which causes the baby unit to consume a lot of energy. Decrease the volume of the baby unit.

Perhaps you have switched on the nightlight. If you want to use the nightlight, we advise you to run the baby unit on electrical power.