Bosch Appliances VG5 600 user manual Getting Started, Powering On, Establishing AutoDome Control

AutoDome 600 Series Analog PTZ CameraGetting Started en 5

1	Getting Started
		Install and wire the AutoDome according to the VG5 AutoDome Installation Manual. A typical
		system includes a keyboard, matrix switcher, monitor, and appropriate wiring connections.
		Please refer to the individual product manuals for complete installation and setup instructions
		for each of the system components.
1.1	Powering On
		When you turn the AutoDome power on there is a ten (10) second pause before the dome
		starts its homing phase. During the homing phase the camera pans left and right and tilts up
		and down. It also adjusts the lens focus. The entire homing phase lasts approximately 40
		seconds and ends with a firmware version screen.
		Bosch Security Sys. AutoDome(r)
		600 Series	5.00.00.03/1.05.00.02
		Day/Night 36X	1.00.00.00
		SC Boot	5.00.00.03
		FPGA	1.13.01.05
		VCA_boot	1.02.00.01
		STD Comm
		No Heater

FastAddress: Not Set

Figure 1.1 Sample VG5 Startup Firmware Version Screen

The splash screen displays the type of AutoDome, the camera installed, the firmware levels for various files, and the current IP address (for VG5 AutoDome 700 Series models).

1.2 Establishing AutoDome Control

The most common ways to interface with the AutoDome are:

–Using a keyboard and on-screen display (OSD) menus. This method is the most common and is covered in this manual.

–Using the AutoDome Configuration Tool software running on a PC with Bilinx or the RS- 232/485 communication protocol. Refer to the CTFID User Manual for instructions.

–Using a PC-based graphical user interface (GUI) such as the Bosch DiBos 8 software. Refer to the DiBos 8 User Guide for instructions.

Bosch Security Systems, Inc. User Manual F.01U.270.005 2.0 2012.06