Bosch Appliances VG5 600 user manual AutoHome Recalibration Commands and Settings, 180 / -45 S

AutoDome 600 Series Analog PTZ CameraAdvanced Features en 53

7.8.2	Displaying Azimuth, Elevation, and Compass Headings
		You can display only the azimuth/elevation readings or only the compass reading, or you can
		display both readings at the same time. The AutoDome displays the azimuth/elevation
		readings and the compass heading in the following way:
		180 / –45 S
		where:
		– 180 is the Azimuth or the pan location in degrees.
		– –45is the Elevation or the tilt location in degrees.
		– S is the compass direction (cardinal or intercardinal).
		1. Press ON-95-ENTERto display the azimuth/elevation reading.
		2. Press ON-96-ENTERto display the compass heading.
		3. Press OFF-95-ENTERto hide the azimuth/elevation reading.
		4. Press OFF-96-ENTERto hide the compass heading.
7.9	AutoHome Recalibration Commands and Settings
		The AutoHoming routine may be enabled for any site that is experiencing a large amount of
		shifts in masks, prepositions, or playback tours. This feature adds the following AUX
		commands to configure and to enable the AutoHome Recalibration feature:
		Function	Command	Command	Description
		Key	Number
		On/Off	680	Homing Recalibration	Displays the current mode of operation,
				Display	intervals, time until the next calibration, and
					the number of recalibrations that have
					occurred.
					On – Turns display on.
					Off – Turns off the display.
		On/Off	681	Homing Recalibration	On – Enables recalibration (This action does
					not cause the dome to re-home immediately)
					Off – Disables recalibration
		On	682	Recalibration Mode	Each On command toggles the recalibration
					mode as follows:
					– Recalibrates only on the loss of home
					position.
					– Recalibrates on the loss of home and for
					every periodic interval.
		On/Off	683	Recalibration Interval	Changes the homing recalibration interval.
					Intervals are in 6-hour increments up to 72
					hours.
					Each On – increases interval by 6 hours
					Each Off – decreases interval by 6 hours
		On/Off	684	Initial Offset Time	Sets the initial offset time for the recalibration
					interval. The offset time starts after the Homing
					Calibration is enabled. The recalibration
					interval begins its countdown after the offset
					time.
					Each On – increases offset time by 4 hours
					Each Off – decreases offset time by 4 hours
					Note: The offset time does not take effect until
					the Homing Calibration is enabled.

Bosch Security Systems, Inc. User Manual F.01U.270.005 2.0 2012.06