Bosch Appliances VG5 600 No camera control, If address is not set or is incorrect, then, Control

56 en Troubleshooting GuideAutoDome 600 Series Analog PTZ Camera

No camera control	–	Ensure that the keyboard and monitor are set to the correct (same) camera number.
	If O.K., then:
	– Check that the camera address is properly set. Enter ON-997-ENTERto display the
		camera address.
	If address is not set or is incorrect, then:
	– Set the camera address using FastAddress (ON-998-ENTER).
	If O.K., then:
	– Check that the Amber LED on the AutoDome CPU turns on when receiving pan/tilt
		commands from the controller keyboard. The Amber LED indicates control is being
		received.
	Amber LED on AutoDome CPU Module
	Flash Sequence
	–	Off
		No incoming communications or no power
	– Solid for 2 seconds
		Receiving good data
	–	Fast blinking
		Lost packet(s)
	If amber LED does not light when given PTZ commands, then:
	– Check if other cameras on the system can be controlled. If not, check the controller
		and wiring connections.
	If O.K., then:
	– Check that the RS-232/485 selector switch is properly set to the proper protocol.
	If O.K., then:
	– Ensure that all Biphase, Bilinx, or RS-232/485 wires are properly connected. See the
		VG5 AutoDome Installation Manual.
	If O.K., then:
	– Check if you can access the AutoDome OSD menus (ON-46-ENTER).
	If O.K., then:
	– Confirm that the AutoDome passes homing (SET-110-ENTER).
	If AutoDome fails homing, then:
	– Contact Bosch Technical Support.
Intermittent camera	–	Check that only the last AutoDome in a daisy chain configuration is terminated with a
control		100 Ω resistor across the +/- biphase terminals.
	If O.K., then:
	– Check that the maximum wire distance has not been exceeded for the control protocol
		(the maximum distance for RS-232 is 50 feet). See the VG5 AutoDome Installation
		Manual.
	If O.K., then:
	– Check that all wiring meets Bosch recommended standards and specifications. See the
		VG5 AutoDome Installation Manual.
Camera moves when	–	Check that the camera address is properly set (ON-997-ENTER). If the camera address
moving other		is not set, the AutoDome responds to control commands to any camera on the system.
cameras	If camera address is not set, then:
	– Invoke the FastAddress Menu to assign a camera address (ON-998-ENTER).
Cannot access user	–	Enter the unlock command OFF-90-ENTER. This command may require a password.
settings		(Commands automatically lock in 30 minutes.)

F.01U.270.005 2.0 2012.06 User Manual Bosch Security Systems, Inc.