Bosch Appliances VG5 600 user manual AutoDome 600 Series Analog PTZ Camera User Command Table en

AutoDome 600 Series Analog PTZ Camera			User Command Table en 63
Function	Comm	Command	Description
Key	No.
On/Off	100	Record A	Activate/Deactivate
On/Off	101	Record B	Activate/Deactivate
On	997	FastAddress, display	Display current address
On	998	FastAddress, all units	Display and program current address
On	999	FastAddress, unaddressed domes	Display and program unaddressed AutoDomes
Set	“1-99”	Pre-position Programming	Set ##–Programs a preset view
Shot	“1-99”	Pre-position Recall	Shot ##–Recall programmed preset
Set	100	Pre-position Menu	Enters the Pre-position menu
Set/Shot	101	Autopan Left Limit	Set–Programs left limit
			Shot–Shows limit
Set/Shot	102	Autopan Right Limit	Set–Programs right limit
			Shot–Shows limit
Set	110	Factory P/T Home Position	Set–Recalibrate home position
On/Off	680	Homing Recalibration Display	Displays the current mode of operation, intervals,
			time until the next calibration, and the number of
			recalibrations that have occurred.
			On – Turns display on.
			Off – Turns off the display.
On/Off	681	Homing Recalibration	On – Enables recalibration (This action does not
			cause the dome to re-home immediately)
			Off – Disables recalibration
On	682	Recalibration Mode	Each On command toggles the recalibration mode
			as follows:
			– Recalibrates only on the loss of home position.
			– Recalibrates on the loss of home and for every
			periodic interval.
On/Off	683	Recalibration Interval	Changes the homing recalibration interval. Intervals
			are in 6-hour increments up to 72 hours.
			Each On – increases interval by 6 hours
			Each Off – decreases interval by 6 hours
On/Off	684	Initial Offset Time	Sets the initial offset time for the recalibration
			interval. The offset time starts after the Homing
			Calibration is enabled. The recalibration interval
			begins its countdown after the offset time.
			Each On – increases offset time by 4 hours
			Each Off – decreases offset time by 4 hours
			Note: The offset time does not take effect until the
			Homing Calibration is enabled.
On	911	Remote Restart	Simulates a power cycle. Once issued the
			AutoDome re-homes and displays the start-up
			splash screen.
Set	900	Edit Tour 1 (Standard)	Enters the Standard Tour Scene menu
Shot	900	Edit Tour 2 (Custom)	Enters the Custom Tour Scene menu
Set/Shot	901-999	Adds/Removes a Preposition Shot from	Set ###–Adds preset
		Tour 1	Shot ###–Removes preset

Bosch Security Systems, Inc. User Manual F.01U.270.005 2.0 2012.06