Sears 23897 user manual Wires, Tip Avoid pinching the wires. Attach the Rear

Page 12

12. Orient the Rear Upright Cover (24) as shown.

12

While a second person holds the Rear Upright	Avoid pinching
Cover (24) near the Upright (5), connect the	Avoid pinching
receiver wire (A) to the Receiver Extension	the wires
Wire (143).

Tip: Avoid pinching the wires. Attach the Rear	5	93
Upright Cover (24) to the Upright (5) with four M4		93
Upright Cover (24) to the Upright (5) with four M4
x 16mm Screws (93). Tip: It may be necessary	24
to bend the upper end of the Rear Upright	24
to bend the upper end of the Rear Upright	A
Cover gently into place around the Upright.
	143
13. Orient the Front Upright Cover (25) as shown.	13
	13
Attach the Front Upright Cover (25) around the
Upright (5) by pressing it into the Rear Upright
Cover (24).		25
		25
	5
	24
14. Identify the Right Front Leg Cover (30).	14
	14
Attach the Right Front Leg Cover (30) to the
Right Upper Body Arm (8) with two M4 x 16mm
Screws (93).
Repeat this step on the other side of the	32
elliptical.
	8	30
	93
	12

Image 12

Contents QUESTIONS? Model No Serial NoCall TOLL-FREE Table of Contents Important Precautions Before YOU Begin Part Identification Chart Assembly Upright Wire Wire with the wire tie Tip Avoid pinching the Upright WireAvoid pinching Screws yet Do not press the Top Cover 23 into place yetTip Avoid damaging the Upright Wire Avoid damagingScrews yet Tighten the two M6 x 12mm ScrewsSee the upper drawing. Locate the Ramp See the lower drawing. Pull upward on111 Wires Tip Avoid pinching the wires. Attach the RearRepeat this step on the other side Elliptical Repeat this step on the other side of the elliptical See the inset drawing. Locate the Pulse Wire Avoid pinching Wires HOW to USE the Elliptical HOW to Plug in the Power CordPage HOW to Exercise on the Elliptical HOW to Level the EllipticalConsole Diagram Features of the ConsoleHOW to Turn on the Power HOW to USE the Manual ModeSelect the manual mode Follow your progress with the displayMeasure your heart rate if desired Heart rate monitor see page 26 for informationAbout the optional chest heart rate monitor Same time, the console will not display yourWhen you are finished exercising, unplug the power cord Turn on the fan if desiredHOW to USE AN Onboard Workout Select an onboard workoutBegin pedaling to start the workout HOW to USE a SET-A-GOAL Workout Set a calories, distance, or time goalHOW to USE AN Ifit Workout Make sure that the iFit module is inserted in the consoleSelect a user Select an iFit workout Start the workout. See onHOW to USE the Sound System Follow your progress with the display. See onOptional Chest Heart Rate Monitor HOW to Change Console Settings FCC Information Maintenance and Troubleshooting HOW to Adjust the Reed SwitchHeart Rate Monitor Troubleshooting HOW to Calibrate the RampHOW to Adjust the Drive Belt Exercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencySuggested Stretches Page Part List Description QtyQty Description Exploded Drawing a Exploded Drawing Exploded Drawing C126 102 Ordering Replacement Parts Limited WarrantyIcon Health & Fitness, Inc., 1500 S W., Logan, UT