Sears 23897 user manual Maintenance and Troubleshooting, HOW to Adjust the Reed Switch

Page 29

MAINTENANCE AND TROUBLESHOOTING

Inspect and tighten all parts of the elliptical regularly. Replace any worn parts immediately.

To clean the elliptical, use a damp cloth and a small amount of mild soap. IMPORTANT: To avoid damage

HOW TO ADJUST THE REED SWITCH

If the console does not display correct feedback, the reed switch should be adjusted.

to the console, keep liquids away from the console and keep the console out of direct sunlight.

HEART RATE MONITOR TROUBLESHOOTING

If the console does not turn on, make sure that the power cord is fully plugged in. If lines appear in the console display, see HOW TO CHANGE CONSOLE SETTINGS on page 27 and adjust the contrast level of the display.

If the console does not display your heart rate when you hold the handgrip heart rate monitor, or if the dis-

To adjust the reed switch, first unplug the power cord. Using a flat screwdriver, release the tabs on the Top Cover

(20)and pry the Top Cover upward off the elliptical.

20

played heart rate appears to be too high or too low, see step 5 on page 21.

HOW TO CALIBRATE THE RAMP

If the ramp is not functioning properly, the ramp may need to be calibrated. To calibrate the ramp, press and hold the Calorie button for several seconds until the test mode appears in the display.

Press the Calorie button again. Press the 1 Step Ramp increase or decrease button to calibrate the ramp. The ramp will move upward and downward as it calibrates.

When the ramp stops moving, the ramp is calibrated. Then, press the Calorie button repeatedly to exit the test mode.

Next, look into the access opening and locate the Reed Switch (69). Rotate the Large Pulley (74) until a Magnet (75) is aligned with the Reed Switch.

93 75

74

69

 

Next, loosen, but do not remove, the indicated M4 x 16mm Screw (93). Slide the Reed Switch (69) slightly toward or away from the Magnet (75). Then, retighten the M4 x 16mm Screw.

Plug in the power cord and rotate the large pulley for a moment. Repeat these actions until the console displays correct feedback. When the reed switch is correctly adjusted, reattach the access cover.

29

Page 28 Page 30
Image 29
Page 28 Page 30
Contents Call TOLL-FREE QUESTIONS?Model No Serial No Table of Contents Important Precautions Before YOU Begin Part Identification Chart Assembly Wire with the wire tie Tip Avoid pinching the Upright Wire Upright WireAvoid pinching Screws yet Do not press the Top Cover 23 into place yetAvoid damaging Tip Avoid damaging the Upright WireTighten the two M6 x 12mm Screws Screws yetSee the lower drawing. Pull upward on See the upper drawing. Locate the Ramp111 Repeat this step on the other side Elliptical WiresTip Avoid pinching the wires. Attach the Rear Repeat this step on the other side of the elliptical See the inset drawing. Locate the Pulse Wire Avoid pinching Wires HOW to Plug in the Power Cord HOW to USE the EllipticalPage HOW to Level the Elliptical HOW to Exercise on the EllipticalFeatures of the Console Console DiagramHOW to USE the Manual Mode HOW to Turn on the PowerSelect the manual mode Follow your progress with the displayHeart rate monitor see page 26 for information Measure your heart rate if desiredAbout the optional chest heart rate monitor Same time, the console will not display yourTurn on the fan if desired When you are finished exercising, unplug the power cordBegin pedaling to start the workout HOW to USE AN Onboard WorkoutSelect an onboard workout Set a calories, distance, or time goal HOW to USE a SET-A-GOAL WorkoutMake sure that the iFit module is inserted in the console HOW to USE AN Ifit WorkoutSelect a user Select an iFit workout Start the workout. See onOptional Chest Heart Rate Monitor HOW to USE the Sound SystemFollow your progress with the display. See on HOW to Change Console Settings FCC Information HOW to Adjust the Reed Switch Maintenance and TroubleshootingHeart Rate Monitor Troubleshooting HOW to Calibrate the RampHOW to Adjust the Drive Belt Exercise Intensity Exercise GuidelinesWorkout Guidelines Exercise FrequencySuggested Stretches Page Description Qty Part ListQty Description Exploded Drawing a Exploded Drawing Drawing C Exploded126 102 Icon Health & Fitness, Inc., 1500 S W., Logan, UT Ordering Replacement PartsLimited Warranty
Top Page Image Contents