Sears 23897 user manual HOW to Adjust the Drive Belt

Page 30

HOW TO ADJUST THE DRIVE BELT

If you can feel the pedals slip while you are pedaling, even when the resistance is adjusted to the highest level, the drive belt may need to be adjusted.

See EXPLODED DRAWING B on page 37. Remove the M4 x 16mm Screws (93) and the M4 x 42mm Screws (124) from the Right and Left Shields (18, 19).

Make sure to note which size Screws come from which holes. Then, carefully remove the Left Shield.

To adjust the drive belt, first unplug the power cord. Using a flat screwdriver, release the tabs on the Top Cover (20) and pry the Top Cover upward off the elliptical.

	20
13	19, 18
13	136
	117
	124

Next, lift the Latch (117) on the underside of the Left Pedal Arm (13), and then lift the Left Pedal Arm off the left Sleeve (136).

Loosen the Pivot Screw (97). Tighten the Belt Adjustment Screw (85) until the Drive Belt (38) is tight. When the Drive Belt is tight, tighten the Pivot Screw.

38

97

85

When you are finished, reattach the left shield, replace the left pedal arm, and reattach the access cover. Then, plug in the power cord.

30

Image 30

Contents QUESTIONS? Model No Serial NoCall TOLL-FREE Table of Contents Important Precautions Before YOU Begin Part Identification Chart Assembly Avoid pinching Upright WireWire with the wire tie Tip Avoid pinching the Upright Wire Screws yet Do not press the Top Cover 23 into place yetTip Avoid damaging the Upright Wire Avoid damagingScrews yet Tighten the two M6 x 12mm ScrewsSee the upper drawing. Locate the Ramp See the lower drawing. Pull upward on111 Wires Tip Avoid pinching the wires. Attach the RearRepeat this step on the other side Elliptical Repeat this step on the other side of the elliptical See the inset drawing. Locate the Pulse Wire Avoid pinching Wires HOW to USE the Elliptical HOW to Plug in the Power CordPage HOW to Exercise on the Elliptical HOW to Level the EllipticalConsole Diagram Features of the ConsoleSelect the manual mode HOW to Turn on the PowerHOW to USE the Manual Mode Follow your progress with the displayAbout the optional chest heart rate monitor Measure your heart rate if desiredHeart rate monitor see page 26 for information Same time, the console will not display yourWhen you are finished exercising, unplug the power cord Turn on the fan if desiredHOW to USE AN Onboard Workout Select an onboard workoutBegin pedaling to start the workout HOW to USE a SET-A-GOAL Workout Set a calories, distance, or time goalSelect a user Select an iFit workout HOW to USE AN Ifit WorkoutMake sure that the iFit module is inserted in the console Start the workout. See onHOW to USE the Sound System Follow your progress with the display. See onOptional Chest Heart Rate Monitor HOW to Change Console Settings FCC Information Heart Rate Monitor Troubleshooting Maintenance and TroubleshootingHOW to Adjust the Reed Switch HOW to Calibrate the RampHOW to Adjust the Drive Belt Workout Guidelines Exercise GuidelinesExercise Intensity Exercise FrequencySuggested Stretches Page Part List Description QtyQty Description Exploded Drawing a Exploded Drawing Exploded Drawing C126 102 Ordering Replacement Parts Limited WarrantyIcon Health & Fitness, Inc., 1500 S W., Logan, UT