Sears 23897 user manual Suggested Stretches

Page 32

SUGGESTED STRETCHES

The correct form for several basic stretches is shown at the right. Move slowly as you stretch; never bounce.

1. Toe Touch Stretch

Stand with your knees bent slightly and slowly bend forward from your hips. Allow your back and shoulders to relax as you reach down toward your toes as far as possible. Hold for 15 counts, then relax. Repeat 3 times. Stretches: Hamstrings, back of knees and back.

2. Hamstring Stretch

Sit with one leg extended. Bring the sole of the opposite foot toward you and rest it against the inner thigh of your extended leg. Reach toward your toes as far as possible. Hold for 15 counts, then relax. Repeat 3 times for each leg. Stretches: Hamstrings, lower back and groin.

3. Calf/Achilles Stretch

With one leg in front of the other, reach forward and place your hands against a wall. Keep your back leg straight and your back foot flat on the floor. Bend your front leg, lean forward and move your hips toward the wall. Hold for 15 counts, then relax. Repeat 3 times for each leg. To cause further stretching of the achilles tendons, bend your back leg as well. Stretches: Calves, achilles tendons and ankles.

4. Quadriceps Stretch

With one hand against a wall for balance, reach back and grasp one foot with your other hand. Bring your heel as close to your buttocks as possible. Hold for 15 counts, then relax. Repeat 3 times for each leg. Stretches: Quadriceps and hip muscles.

5. Inner Thigh Stretch

Sit with the soles of your feet together and your knees outward. Pull your feet toward your groin area as far as possible. Hold for 15 counts, then relax. Repeat 3 times. Stretches: Quadriceps and hip muscles.

1

2

3

4

5

32

Image 32
Contents Call TOLL-FREE QUESTIONS?Model No Serial No Table of Contents Important Precautions Before YOU Begin Part Identification Chart Assembly Upright Wire Wire with the wire tie Tip Avoid pinching the Upright WireAvoid pinching Screws yet Do not press the Top Cover 23 into place yetTip Avoid damaging the Upright Wire Avoid damagingScrews yet Tighten the two M6 x 12mm ScrewsSee the upper drawing. Locate the Ramp See the lower drawing. Pull upward on111 Repeat this step on the other side Elliptical WiresTip Avoid pinching the wires. Attach the Rear Repeat this step on the other side of the elliptical See the inset drawing. Locate the Pulse Wire Avoid pinching Wires HOW to USE the Elliptical HOW to Plug in the Power CordPage HOW to Exercise on the Elliptical HOW to Level the EllipticalConsole Diagram Features of the ConsoleHOW to Turn on the Power HOW to USE the Manual ModeSelect the manual mode Follow your progress with the displayMeasure your heart rate if desired Heart rate monitor see page 26 for informationAbout the optional chest heart rate monitor Same time, the console will not display yourWhen you are finished exercising, unplug the power cord Turn on the fan if desiredBegin pedaling to start the workout HOW to USE AN Onboard WorkoutSelect an onboard workout HOW to USE a SET-A-GOAL Workout Set a calories, distance, or time goalHOW to USE AN Ifit Workout Make sure that the iFit module is inserted in the consoleSelect a user Select an iFit workout Start the workout. See onOptional Chest Heart Rate Monitor HOW to USE the Sound SystemFollow your progress with the display. See on HOW to Change Console Settings FCC Information Maintenance and Troubleshooting HOW to Adjust the Reed SwitchHeart Rate Monitor Troubleshooting HOW to Calibrate the RampHOW to Adjust the Drive Belt Exercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencySuggested Stretches Page Part List Description QtyQty Description Exploded Drawing a Exploded Drawing Exploded Drawing C126 102 Icon Health & Fitness, Inc., 1500 S W., Logan, UT Ordering Replacement PartsLimited Warranty