17.Have a second person hold the Handlebar (10) near the Upright (5).
See the inset drawing. Locate the Pulse Wire
(135)in the Handlebar (10). Insert the Pulse Wire into the front of the Upright (5) and pull it out of the hole in the Upright as shown.
Tie the end of the wire tie to the Upright Wire (60), the Receiver Extension Wire (143), and the Pulse Wire (135). Then, insert the other end of the wire tie upward through the Handlebar (10). Next, pull the upper end of the wire tie until the Upright Wire, the Receiver Extension Wire, and the Pulse Wire are routed through the Upright.
18.Tip: Avoid pinching the wires. Attach the Handlebar (10) to the Upright (5) with two M8 x 16mm Screws (102).
17 | 10 |
| |
| 135 |
| 5 |
| 10 |
Wire | 5 |
Tie | 60, 143, |
| |
| 135 |
18 |
Avoid pinching |
the wires |
10 |
102 |
5 |
14