Sears 23897 user manual FCC Information

Page 28

FCC INFORMATION

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, try to correct the interference by one or more of the following measures:

•• Reorient or relocate the receiving antenna.

•• Increase the separation between the equipment and the receiver.

•• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. •• Consult the dealer or an experienced radio/TV technician for help.

FCC CAUTION: To assure continued compliance, use only shielded interface cables when connecting to computer or peripheral devices. Changes or modifications not expressly approved by the party respon- sible for compliance could void the user’’s authority to operate this equipment.

28

Image 28
Contents Model No Serial No QUESTIONS?Call TOLL-FREE Table of Contents Important Precautions Before YOU Begin Part Identification Chart Assembly Upright Wire Wire with the wire tie Tip Avoid pinching the Upright WireAvoid pinching Screws yet Do not press the Top Cover 23 into place yetTip Avoid damaging the Upright Wire Avoid damagingScrews yet Tighten the two M6 x 12mm ScrewsSee the upper drawing. Locate the Ramp See the lower drawing. Pull upward on111 Tip Avoid pinching the wires. Attach the Rear WiresRepeat this step on the other side Elliptical Repeat this step on the other side of the elliptical See the inset drawing. Locate the Pulse Wire Avoid pinching Wires HOW to USE the Elliptical HOW to Plug in the Power CordPage HOW to Exercise on the Elliptical HOW to Level the EllipticalConsole Diagram Features of the ConsoleHOW to Turn on the Power HOW to USE the Manual ModeSelect the manual mode Follow your progress with the displayMeasure your heart rate if desired Heart rate monitor see page 26 for informationAbout the optional chest heart rate monitor Same time, the console will not display yourWhen you are finished exercising, unplug the power cord Turn on the fan if desiredSelect an onboard workout HOW to USE AN Onboard WorkoutBegin pedaling to start the workout HOW to USE a SET-A-GOAL Workout Set a calories, distance, or time goalHOW to USE AN Ifit Workout Make sure that the iFit module is inserted in the consoleSelect a user Select an iFit workout Start the workout. See onFollow your progress with the display. See on HOW to USE the Sound SystemOptional Chest Heart Rate Monitor HOW to Change Console Settings FCC Information Maintenance and Troubleshooting HOW to Adjust the Reed SwitchHeart Rate Monitor Troubleshooting HOW to Calibrate the RampHOW to Adjust the Drive Belt Exercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencySuggested Stretches Page Part List Description QtyQty Description Exploded Drawing a Exploded Drawing Exploded Drawing C126 102 Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT