Sears 23897 See the upper drawing. Locate the Ramp, See the lower drawing. Pull upward on

Page 10

8. See the upper drawing. Locate the Ramp	8
Roller (92) on the Right Pedal Arm (12).	8
Roller (92) on the Right Pedal Arm (12).
Set the Ramp Roller (92) on the right side of the
Ramp (43).	92	12
See the lower drawing. Pull upward on the
Latch (117) on the Right Pedal Arm (12).
Press the Right Pedal Arm (12) onto the right
Sleeve (136). Make sure that the Right Pedal
Arm latches into place.
Repeat this step on the other side of the
elliptical.	43
	43
		12
		117
	136
9. Orient the Ramp Cover (44) around the Upright	9
(5) as shown.	9
(5) as shown.
Press the mounts on the underside of the Ramp
Cover (44) into the Ramp (43).	44
	44
	5	43
		43
	10

Image 10

Contents Model No Serial No QUESTIONS?Call TOLL-FREE Table of Contents Important Precautions Before YOU Begin Part Identification Chart Assembly Avoid pinching Upright WireWire with the wire tie Tip Avoid pinching the Upright Wire Screws yet Do not press the Top Cover 23 into place yetTip Avoid damaging the Upright Wire Avoid damagingScrews yet Tighten the two M6 x 12mm ScrewsSee the upper drawing. Locate the Ramp See the lower drawing. Pull upward on111 Tip Avoid pinching the wires. Attach the Rear WiresRepeat this step on the other side Elliptical Repeat this step on the other side of the elliptical See the inset drawing. Locate the Pulse Wire Avoid pinching Wires HOW to USE the Elliptical HOW to Plug in the Power CordPage HOW to Exercise on the Elliptical HOW to Level the EllipticalConsole Diagram Features of the ConsoleSelect the manual mode HOW to Turn on the PowerHOW to USE the Manual Mode Follow your progress with the displayAbout the optional chest heart rate monitor Measure your heart rate if desiredHeart rate monitor see page 26 for information Same time, the console will not display yourWhen you are finished exercising, unplug the power cord Turn on the fan if desiredSelect an onboard workout HOW to USE AN Onboard WorkoutBegin pedaling to start the workout HOW to USE a SET-A-GOAL Workout Set a calories, distance, or time goalSelect a user Select an iFit workout HOW to USE AN Ifit WorkoutMake sure that the iFit module is inserted in the console Start the workout. See onFollow your progress with the display. See on HOW to USE the Sound SystemOptional Chest Heart Rate Monitor HOW to Change Console Settings FCC Information Heart Rate Monitor Troubleshooting Maintenance and TroubleshootingHOW to Adjust the Reed Switch HOW to Calibrate the RampHOW to Adjust the Drive Belt Workout Guidelines Exercise GuidelinesExercise Intensity Exercise FrequencySuggested Stretches Page Part List Description QtyQty Description Exploded Drawing a Exploded Drawing Exploded Drawing C126 102 Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT