A
B
Figure 11 Cable adjust- ment parts
A: Barrel adjuster
B: Locknut
To adjust the brakes (cont.)
6. Turn the barrel adjuster (Figure 11) out one or two turns. Turn the barrel adjuster locknut to hold the adjustment.
If the pads are not
7. Tape the handlebar.
To function check the brakes
1. Make sure the pads meet the rim squarely (with a slight
2. Check that the pads cannot contact the tire during any part of the wheel rotation.
3.Apply the brake lever fully and make sure the lever cannot contact the handlebar.
4.Check that the cable does not slip in the cable clamp.
5.Check that the brake applies adequate stopping power.
6.Check that the brake does not squeal when applied.