the iron, while turning the temperatu- re regulator of the iron in a clockwise direction. (Fig 2)
-Move the iron in a top to bottom direction while pressing the steam control (B). Important: for cotton and linen, its recommended to put the iron base in contact with the material. For other more delicated fibres, it’s recommended to keep the iron base at some centimetres of distance.
Once you have finished using the appliance:
-Select the minimum position (MIN) using the thermostat control.
-Unplug the appliance to the mains.
-Remove the water from the water tank.
-Clean the appliance
Cleaning
-Disconnect the appliance from the mains and let it cool before underta- king any cleaning task.
-Clean the equipment with a damp cloth with a few drops of
-Do not use solvents, or products with an acid or base pH such as blea- ch, or abrasive products, for cleaning the appliance.
-Do not submerge the appliance in water or any other liquid, or place it under a running tap.
Self-cleaning function:
-It is important to
up minerals inside the iron.
-Fill the depository to its maximum level, as indicated on “water fill” section.
-Place the iron in a vertical position, plug in to the mains m and select the maximum temperature.
-Leave the appliance to heat up until the pilot light indicates that it has reached its consigned temperature.
-Unplug the appliance and place in the sink.
-Press the
-Let the water flow out through the steam vents in the base, while lightly shaking the appliance.
-Release the button after a minute or when the tank becomes empty.
-Leave the iron in the vertical posi- tion until it has cooled.
Anomalies and repair
-Take the appliance to an authorised technical support service if problems arise. Do not try to dismantle or repair without assistance, as this may be dangerous.
-If the connection to the mains has been damaged, it must be replaced and you should proceed as you would in the case of damage.
For EU product versions and/or in case that it is requested in your country: