1.Drape the power cord over the washer top.
2.Move the washer to its final location.
3.Place the drain hose in the laundry tub or standpipe as shown. See illustrations A and B.
C
4.If the washer faucets and the drain standpipe are recessed, put the hooked end of the drain hose in the standpipe as shown. See illustration C.
NOTES:
•Do not force excess drain hose back into the rear of the washer.
•To avoid siphoning, do not seal the drain hose into the standpipe.
One foot has been installed at a different height on your new washer. The other three feet were preset at the factory. Properly leveling your washer will minimize excessive noise and vibration.
1.Push on the upper front panel to be sure that the washer is on the rear feet. Lower right front foot until it contacts the floor. Check the levelness of the washer by placing a level on the top edge of the washer, first side to side, then front to back.
If the washer is against a wall, move the washer out slightly before tipping back, If the washer is not level, first prop the front with a wood block and adjust the feet as necessary; then prop the back and adjust feet as necessary. Repeat this step until washer is level.
2.Make sure that all four feet are stable and resting on the floor. Then check that the appliance is perfectly level (use a level).
3.After the washer is level, use a 17 mm
IMPORTANT: All four feet must be tightened, If the nuts are not tight against the washer cabinet, the washer may vibrate,
4.When you are pushing on the edges of the washing machine top plate, the machine should not move front to back, side to side, or diagonally.
5.Slide the washer to its final location,
6.Confirm the levelness of the washer.
1.Check the electrical requirements. Be sure that you have the correct electrical supply and the recommended grounding method. See "Electrical Requirements."
2.Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped.
3.Check that you have all of your tools.
4.Dispose of or recycle all packaging materials.
5.Check that the water faucets are on,
6.Check for leaks around faucets and inlet hoses.
ElectricaB Shock Hazard
Pmug into a grounded 3 prong outmet,
Do not remove ground prong,
Do not use an adapter,
Do not use an extension cord,
Faimure to follow these instructions can resumt in death, fire, or electricam shock,
7.Plug into a grounded 3 prong outlet.
8.Read "Washer Use."
9.To test and to clean your washer, using only "HE" High Efficiency detergent, measure 1/2the amount of detergent recommended by the manufacture for a medium size load. Pour the detergent into the detergent dispenser. Select NORMAL/CASUAL, and then select START. Allow the washer to complete one whole cycle.
Use only HE High Efficiency detergent.
11