Maytag W10092684A manual Connect Drain Hose, Remove drain hose from washer cabinet

6.Remove tape from lid. Open lid and remove foam packing ring from washer tub. Keep foam packing ring in case you need to move the washer in the future.

Remove drain hose from washer cabinet

Pull the corrugated drain hose out of the washer by first grabbing the pull tie. Continue to pull the hose until the end emerges. Do not force excess drain hose back into the rear of the washer.

Connect Drain Hose

Proper connection of the drain hose protects your floors from damage due to water leakage.

Read and follow these instructions.

The drain hose is connected to your washer and is stored inside the washer cabinet.

Laundry tub drain or standpipe drain

Connecting the drain hose form to the corrugated drain hose

A

4.5"

(11.4 cm)

A. Drain hose reliefs

1. Feed end of drain hose into one end of form. Place end of drain hose form into the drain hose relief.

2. Bend the hose over the top of the form and feed into the other end of the form. Attach the other end of the form into the other drain hose relief. The hose must extend 4½" (11.4 cm) beyond the form.

To keep drain water from going back into the washer:

■ Do not force excess drain hose into standpipe. Hose should be secure but loose enough to provide a gap for air.

■ Do not lay excess hose on the bottom of the laundry tub.

8