IGNITION SYSTEM OPERATIONS
The igniter supplies a spark to the igniter electrode assembly. Whether you are performing routine maintenance or a troubleshooting check on the ignition system, read the following to keep your ignition system working properly.
mWARNING: All gas controls and supply valves should be in the OFF position.
If the igniter fails to ignite your Q® grill, you will need to pinpoint where the problem is occurring: with the gas flow or with the ignition system. Begin by attempting to match light your burner. Refer to “BURNER
MAINTAINING THE ELECTRONIC IGNITION SYSTEM
•Verify that the AAA battery (alkaline only) is in good condition and is installed correctly (1). Some batteries have a plastic protective wrap around them. This plastic must be removed before installing battery. Do not confuse this plastic with the battery label.
•Make sure that both igniter wires are properly attached to the igniter module. Black wire to black terminal (2), white wire to white terminal (3).
•Make sure the electronic igniter button is working by listening for clicking and looking for sparks at burner.
If the electronic ignition system still fails to ignite, contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®.
MAINTAINING THE GRILL OUT®
HANDLE LIGHT
•Verify that the three AAA batteries (alkaline only) are in good condition and are installed correctly. Refer to “ASSEMBLY.”
•Some batteries have a plastic protective wrap around them. This plastic must be removed before installing battery. Do not confuse this plastic with the battery label.
ROUTINE MAINTENANCE
1
3
2
34WWW.WEBER.COM®