Ducane 3100 | 4100 | 4200 owner manual Match Lighting Your Grill Main Burners

NORMAL OPERATION

Match Lighting Your Grill Main Burners

mDANGER: Failure to open the lid while igniting the barbecue’s burners, or not waiting five minutes to allow the gas to clear if the barbecue does not light, may result in an explosive flare-up which can cause serious bodily injury or death.

A)Open the lid (1) and make sure that all burners are in the “OFF” position (2).

B)Turn the cylinder on by slowly turning the cylinder valve counterclockwise (3).

mWARNING: The burner control knobs must be in the OFF position before turning on the LP cylinder valve (3). If they are not in the OFF position, when you turn on the LP cylinder valve, the “excess gas flow control” feature will activate, limiting the flow of gas from the LP cylinder. If this should occur, turn OFF the LP cylinder valve and burner control knobs. Start over.

mDANGER: When the “excess gas flow control” feature is activated, a small amount of gas is still flowing to the burners. After turning off the LP cylinder valve and burner control knobs, wait at least five minutes for the gas to clear before attempting to light the grill. Failure to do so may result in an explosive flare-up, which can cause serious bodily injury or death.

C)Ignite the burners individually from left to right. Begin with the burner on the left (4). Put match in the match holder and strike match. Insert match holder with lit match

(5) down through cooking grates, past the heat distribution plates and adjacent

to the left burner. Push control knob in and turn it to HIGH to ignite the left burner. Check that the left burner is lit by looking through the cooking grates. You should see a flame (6).

ARRÊTÉ - OFF - APAGADO

2
HIGH
	LOW
MED			1
MAIN BURNER
	5			6
				2
	4	7
			10
				3
3100

	1
m WARNING: Do not lean over the open barbecue.

D1) (MODEL 3100 ONLY)
Ignite center burner (7) by putting match in the match holder and striking match.	5
Then, insert match holder with lit match down through cooking grates, past the heat
distribution plates and adjacent to the center burner. Push control knob in and turn
it to HIGH to ignite the center burner. Check that the center burner is lit by looking
through the cooking grates.
OR
D2) (MODEL 4100/4200)
a) Ignite center-left burner (8) by putting match in the match holder and striking
match. Then, insert match holder with lit match down through cooking grates,	4 8
past the heat distribution plates and adjacent to the center-left burner. Push
control knob in and turn it to HIGH to ignite the center-left burner. Check that the		9 10
center-left burner is lit by looking through the cooking grates.
b) Next, ignite center-right burner (9) by putting match in the match holder and
striking match. Then, insert match holder with lit match down through cooking	4100/4200
grates, past the heat distribution plates and adjacent to the center-right burner.

Push control knob in and turn it to HIGH to ignite the center-right burner. Check that the center-right burner is lit by looking through the cooking grates.

E)Ignite right burner (10) by putting match in the match holder and striking match. Then, insert match holder with lit match down through cooking grates, past the

heat distribution plates and adjacent to the right burner. Push control knob in and turn it to HIGH to ignite the right burner. Check that the right burner is lit by looking through the cooking grates.

mWARNING: If any burner fails to ignite during lighting, within

five seconds, stop, turn the burner control knob to OFF and
wait five minutes to allow the gas to clear before you try
again or light with a match.	5

6 2

3

6

29