Weber 56069 manual Installation, Locating Your BUILT-IN Side Burner Appliance

INSTALLATION 7

LOCATING YOUR BUILT-IN SIDE BURNER APPLIANCE

When determining a suitable location for your Built-In Side Burner installation, give attention to concerns such as exposure to wind, proximity to traffic paths, and keeping any gas supply lines as short as possible. Never locate the Summit® Built-In Side Burner in a garage, breezeway, shed, under overhang, or other enclosed area. Locate the Side Burner and structure so there is enough room to safely evacuate the area in case of a fire.

B

CLEARANCE FROM COMBUSTIBLE SURFACES OR STRUCTURES

WARNING: Clearance from the outside walls of the sides and back of the Built-In Side Burner must be a minimum of 24 inches (61 cm) from any combustible surface. Refer to “Installation/Gas Instructions” section before starting installation.

DANGER

The structure, “island” counter tops and adjacent work areas for the Built-In Side Burner installation must be built from noncombustible materials only. Incorrect installation may result in a fire, which can cause serious bodily injury or death, and cause damage to property.

NOTE: If you have questions on what materials are considered noncombustible, contact you local building supplier or fire department.

BUILT-IN STRUCTURE CUTOUT DIMENSIONS

All dimensions are to finished surfaces.

C

B

A B C B A

	1
	SIDE BURNER LOCATION
A	Any Surface
B	24" (61 cm) From Any Combustible Surface
C	Side Burner

1Note: For a countertop treatment: Recommended 3/4" (19 mm) overhang. Notch front edge for frame to fully slide in.

SIDE BURNER

	Cut out Dimensions	Tolerances
A	12 3/8" (31.4 cm)	+ 1/8"	- 1/8" (3.18mm)
B	7 7/8" (20 cm)		-
C	27" (68.6 cm)	+ 1/8"	- 1/8" (3.18mm)

A

WARNING: All counter top finished surfaces must be constructed of a noncombustible material.

WWW.WEBER.COM®