A&D FX-120i/FX-200i/FX-300i/FX1200i/FX2000i/FX3000i Calibration Test Using an External Weight

7-3 Calibration Test Using an External Weight

This function tests the balance weighing accuracy using an external weight and outputs the result. This is available only when the “GLP output (info)” parameter is set to “1” or “2”. (Calibration test does not perform calibration.)

Operation

1 Connect the AC adapter and warm up the balance for at least 30 minutes with nothing on the pan.

2 Press and hold the CAL key until displayed, and then release the key.

CCout

is

3 The balance displays CC 0 .

If you want to change the target weight (a list of usable weights is shown on page 23), press the SAMPLE key and proceed to step 4.

If you use the target weight value stored in the balance, proceed to step 5.

4 Specify the target weight value as follows:

SAMPLE key To switch the display condition to: “All of the segments blinking” (target weight selection mode) or “The last two digits blinking” (value adjustment mode).

RE-ZERO key (To increase the value)

MODE key (To decrease the value)

To select the target weight or adjust the value.

PRINT		key	To store	the	new weight
			value. Even		if the AC
			adapter is removed, the data
			is maintained in non-volatile
			memory.
CAL	key		To cancel the operation and
			return to	CC	0	.

26