Lucent Technologies 8411 manual Three Default Feature Option Screens

Page 20

The second line on each feature option screen shows the features you can access. To use any of these features, you must press the softkey below the feature name or abbreviation. For example, on the feature option screen shown above, you can leave a message for another extension to call you back by pressing the softkey below LWC (the Leave Word Calling feature). If you want to cancel the message, press the softkey below CnLWC (the Cancel Leave Word Calling feature).

To see the next set of four features, press the display control button labeled Next ; to move

back a screen, press the display control button labeled Prev . Press Next or Prev until the feature you want to use appears on the second line.

The following flowchart (Figure 5) shows the default features for the three feature option screens. These are the 12 softkey features available when the voice terminal (with display) is shipped from the factory. Also, see “Other Softkey Features That May Be On Your Display” in this section.

LWC CnLWC

AutCB

Timer

CFrwd CPark

TmDay PCall

Cancel

Timer

LWC

Prog

Pause

Mark

Wait

Leave

Automatic

Word

Callback

Call

Priority

Calling

Park

Calling

Call

Time/

Forwarding

Date

AD

AD

Pause

Wait

Abbreviated

AD

Dialing (AD)

Mark

Program

Figure 5. The Three Default Feature Option Screens

Note:

Press

An error tone (one beep) sounds when you have made a mistake in your softkey entries. Exit at any time to exit softkey mode and return to Normal (call-handling) Mode.

17

Image 20

Contents Voice Terminal User’s Guide Contents Page Your 8411 Voice Terminal Top View of the 8411D Voice Terminal With DisplayThese four buttons are labeled Has raised bars for Volume control button Telephone number card Handset Bottom View of the 8411 Voice Terminal Rear View of the 8411 Voice Terminal PassageWay Connection Connection with Analog EquipmentPassageWay Green Light Red Light Status Sharing the 8411 Telephone Line with the Analog Adjunct Which has control Red light Telephone line?Quick Look at the Features Voice FeaturesPage Hold Display Features and Features Used with the Softkeys Normal See Exit How to Use the Features General InstructionsQuick Reference Lists at the Back of This Guide Conventions Used in The Following ProceduresTroubleshooting Later in This Guide Using the Display, Softkeys and Display Control Buttons Display, Softkeys, and Display Control ButtonsThree Default Feature Option Screens Other Softkey Features That May Be On Your Display Abbreviation FeatureUsing the Softkeys to Activate a Feature Voice Feature Procedures Abbreviated Dialing ADTo program/reprogram To end programming Automatic Callback Bridging/Manual Exclusion Call Coverage/Consult Call Forwarding All Calls Call Park Call Pickup ConferenceDrop DiagnosticsHandset Volume Hold Intercom Automatic/DialWhile off Last Number Dialed Leave Word Calling LWCMessage Mute Priority CallingSelect Ring and Ringer Volume Ringer L H Send All Calls Speaker Speakerphone There are eight possible volume settings. On the display Test/Diagnostics TransferTo send present call to another Press Display Feature Procedures Call InformationDirectory Last name, comma use * , first name or initialExit Normal InspectMessage Retrieval Normal ExitStored Number Timer Time/DateFeedback Tones Tones and Their MeaningRinging Tones Troubleshooting Problem SolutionFeature System 75 Version Changes in Feature Operation System 75 Version NotesAccess code See feature access code Key Words to KnowPage Page Quick Reference Lists Miscellaneous

Related manuals

Manual 31 pages 1.6 Kb