Troubleshooting
Problem |
| Solution |
|
|
|
A feature doesn’t work as | 1 | Reread the procedure and try again. |
noted in this guide. | 2 | For many features you must lift the handset before you can use |
| ||
|
| the feature. |
| 3 | Check with your system manager to be sure this feature is |
|
| administered on your voice terminal. |
| 4 | You may have an older version of System 75; thus, some |
|
| features may operate differently from the procedures described |
|
| in this guide. Check the section below on “System 75 Version |
|
| Notes” for ways in which these features work differently. |
|
| |
There are no feature access | See your system manager for a list of feature access codes for fea- | |
codes written in the appro- | tures assigned to your voice terminal. | |
priate blanks in this guide. | Then, write the codes in this guide. | |
|
|
|
Problem |
|
|
| Solution | ||
|
|
|
|
|
|
|
There’s no dial tone. | 1 | Check with your system manager to be sure your voice | ||||
|
| terminal is administered correctly. | ||||
| 2 | Make sure the handset and line cords at your voice terminal are | ||||
|
| securely connected at both ends. | ||||
| 3 | Press |
| . If the red light next to |
| does not go on or |
| Test | Test | ||||
|
| flashes rather than goes on steadily, the voice terminal is not | ||||
|
| communicating with the PBX. | ||||
| 4 | Find a working voice terminal of the same type as your own. | ||||
|
| Unplug this voice terminal from its modular wall jack. Plug | ||||
|
| your voice terminal into that jack and check if it gets dial tone. | ||||
| 5 | If your voice terminal still does not work, plug the working | ||||
|
| voice terminal (of the same type) into your modular wall jack. | ||||
|
| If the working voice terminal has dial tone, your own voice | ||||
|
| terminal is faulty. See your system manager. | ||||
|
|
|
|
|
|
|
50