NAME OF PARTS
Fig. 1 Indoor Unit
1Operating Control Panel (Fig. 2)
2 MANUAL AUTO button
●When kept on pressing the MANUAL AUTO button for more than 10 seconds, the forced cooling operation will start.
●The forced cooling operation is used at the time of installation.
Only for authorized service personnel's use.
●When the forced cooling operation starts by any chance, press the START/STOP but- ton to stop the operation.
3Indicator (Fig. 3)
4Remote Control Signal Receiver
5 OPERATION Indicator Lamp (red)
6 TIMER Indicator Lamp (green)
●If the TIMER indicator lamp flashes when the timer is operating, it indicates that a fault has occurred with the timer setting (See Page 13 Auto Restart).
7SUPER QUIET Indicator Lamp (orange)
8Intake Grille (Fig. 4)
9 Front Panel
0 Air Filter
A Air Flow Direction Louver B Power Diffuser
C
(behind Air Flow Direction Louver) D Drain Hose
Fig. 5 Outdoor Unit
EIntake Port F Outlet Port G Pipe Unit
H Drain port (bottom)
●Refer to the folded out page on the cover.
Fig. 6 Remote Control Unit 
ISLEEP button
JMASTER CONTROL button K SET TEMP. button ( 
/ 
) L Signal Transmitter
M TIMER MODE button
N TIMER SET ( 
/ 
) button O FAN CONTROL button
P START/STOP button Q SET button (Vertical) R SET button (Horizontal) S SWING button
T RESET button
U TEST RUN button
●This button is used when installing the conditioner, and should not be used un- der normal conditions, as it will cause the air conditioner’s thermostat function to op- erate incorrectly.
●If this button is pressed during normal op- eration, the unit will switch to test opera- tion mode, and the Indoor Unit’s OPERA- TION Indicator Lamp and TIMER Indicator Lamp will begin to flash simultaneously.
●To stop the test operation mode, press the START/STOP button to stop the air condi- tioner.
VCLOCK ADJUST button
WRemote Control Unit Display (Fig. 7) X Transmit Indicator
Y Clock Display
Z Operating Mode Display [ Timer Mode Display
\ Fan Speed Display
] Temperature SET Display ` SLEEP Display
a SWING Display