OPERATION
To Select Mode Operation
1 | Press the START/STOP button (Fig.6 P). |
The indoor unit’s OPERATION Indicator Lamp (red) (Fig. 3 5) will light. | |
| The air conditioner will start operating. |
2 | Press the MASTER CONTROL button (Fig.6 J) to se- |
lect the desired mode. |
Each time the button is pressed, the mode will change in the following order.
sAUTO s COOL s DRY sFAN 
About three seconds later, the entire display will reappear.
To Set the Thermostat
Press the SET TEMP. button (Fig. 6 K).
button: Press to raise the thermostat setting. 
button: Press to lower the thermostat setting.
●Thermostat setting range:
AUTO | |
Cooling/Dry |
The thermostat cannot be used to set room temperature during the FAN mode (the temperature will not appear on the Remote Control Unit’s Display).
About three seconds later, the entire display will reappear.
The thermostat setting should be considered a standard value, and may differ somewhat from the actual room temperature.
Example: When set to COOL.
Example: When set to 80 °F.
To Set the Fan Speed
Press the FAN CONTROL button (Fig. 6 O).
Each time the button is pressed, the fan speed changes in the following order:
sAUTO | s HIGH | s MED | sLOW | sQUIET |
About three seconds later, the entire display will reappear.
When set to AUTO:
Cooling | : As the room temperature approaches that of the thermostat setting, |
| the fan speed becomes slower. |
Fan | : The fan runs at the low fan speed. |
SUPER QUIET Operation
Example: When set to AUTO.
When set to Quiet:
SUPER QUIET Indicator Lamp (orange) (Fig. 3 7) will light.
SUPER QUIET operation begins. The indoor unit’s airflow will be reduced for qui- eter operation.
●SUPER QUIET operation cannot be used during Dry mode. (The same is true when dry mode is selected during AUTO mode operation.)
●During Super Quiet operation, Cooling performance will be reduced somewhat. If the room does not cool down when using SUPER QUIET Operation, please adjust the air conditioner’s Fan Speed.