Hitachi C 10FCD instruction manual Practical Applications, Securing the workpiece

English

4.Securing the workpiece

WARNING: Always clamp or vise to secure the workpiece to the fence; otherwise the workpiece

might be thrust from the table and cause bodily harm.

5. Installing the extension wings (Optional accessory)

The extension wings help keep longer workpieces stable and in place during the cutting operation.

		(1)	Insert the 8 mm screw into the hole located on the base.
		(2)	Set the lock support rod under the side of the base.
Extension		(3)	Then with the 8 mm screw for the lock support rod temporary
Wing
			stop.
		(4)	Insert an extension wing into the two holes of the lock support
			rod.
		(5)	Push an extension wing until it contact with the base.
	Fig. 13	(6)	Fasten the 8 mm screw and fix an extension wing.
			CAUTION: When transporting or carrying the tool, do not
Extension			grasp the extension wing.
Wing			There is the danger of the extension wing slipping

out of the base. Grasp the handle (see Fig. 1) instead of the extension wing.

Lock Support

Rod

8 mm Screw

Base

Fig. 14

6. Stock stop for precision cutting (Stock stop is optional accessory)

Extension Wing

Stock Stop

The stock stop facilitates continuous precision cutting in lengths of 10" to 16-21/32" (253 mm to 423 mm). To install the stock stop, attach it to the extension wing with the 6 mm wing bolt as shown in Fig. 15.

6 mm Wing Bolt

Fig. 15

PRACTICAL APPLICATIONS

WARNING: * To avoid personal injury, never remove or place a workpiece on the table while the tool is being operated.

*Never place your limbs inside of the line next to warning sign while the tool is being operated. This may cause hazardous conditions (see Fig. 16).

Line Warning Sign Warning Sign Line

Fig. 16

14