7350
Users Manual
If the original packing and shipping materials were retained, use them for packing the RUSKA 7350. If the RUSKA 7350 is being packed for
1.Fluke has an RMA procedure in place. Please contact the Customer Service Center to obtain an RMA number prior to returning any equipment to Fluke. Have the following information available when contacting Fluke:
•the part number,
•the serial number,
•the purchase order number,
•the billing and ship to address, and
•the buyer’s name and telephone number.
This information plus the RMA number must be attached to the unit when it is shipped to Fluke Calibration. There will be a minimal charge for inspection and/or evaluation of returned goods.
2.Enclose the RUSKA 7350 in plastic or any good water barrier material.
3.Interior Carton (size 30 x 30 x 30 inches): Cover bottom and sides with no less than 3 inches of polyfoam. Use four strips 4" to 6" wide and 50" to 60" long. Arrange strips to cross each other inside carton. Cover sides and top, completely filling entire carton. Tape carton closed.
4.The Exterior Carton must be a double wall of corrugated or fiberboard box. Use four 3 x 3 x 84 inch strips of polyfoam crossing each other inside the carton. Place interior carton inside, making sure exterior carton is completely filled. Do not close the carton yet.
5.Inside the exterior carton, include the following:
a.Statement of the problem or service needed. Be specific. Include the name and telephone number of a knowledgeable technician for consultation.
b.The part number, serial number, return address, and purchase order number.
6.Seal the carton, using gummed tape.
7.Address the carton to:
FLUKE CALIBRATION
10311 WESTPARK DRIVE
HOUSTON, TX 77042
USA
8.Label the carton with the following labels: THIS SIDE UP, HANDLE WITH CARE, DO NOT DROP, and FRAGILE.