Porter-Cable 1000002853 instruction manual Glossary, Risk from Noise, Model No C6001

			HAZARD
		RISK FROM NOISE
	WHAT CAN HAPPEN			HOW TO PREVENT IT
• Under some conditions				• Always wear certified safety
and duration of use, noise				equipment: ANSI S12.6
from this product may				(S3.19) hearing protection.
contribute to hearing loss.

SAVE THESE INSTRUCTIONS

FOR FUTURE USE

pump should not run more thanSPECIFICATIONS30-45 minutes in any given hour.

Model No.	C6001
Running Horsepower	*1.1
Bore	1.875"
Stroke	1.25"
Voltage/Hz-Single Phase	120/60
Minimum Branch Circuit Requirement	15 amps
Fuse Type	Time Delay
Air Tank Capacity (Gallon)	17
Approximate Cut-in Pressure	120 PSIG
Approximate Cut-out Pressure	150 PSIG
SCFM @ 40 PSIG	*4.3
SCFM @ 90 PSIG	*3.3

*Tested per ISO 1217

Refer to Glossary for abbreviations.

GLOSSARY

Become familiar with these terms before operating the unit. CFM: Cubic feet per minute.

SCFM: Standard cubic feet per minute; a unit of measure of air delivery.

PSIG: Pounds per square inch gauge; a unit of measure of pressure.

Code Certification: Products that bear one or more of the following marks: UL, CUL, ETL, CETL, have been evaluated by OSHA certified independent safety labo- ratories and meet the applicable Standards for Safety.

Cut-In Pressure: While the motor is off, air tank pressure drops as you continue to use your accessory. When the tank pressure drops to a certain lower level the motor will restart automatically. The low pressure at which the motor automatically restarts is called "cut-in" pressure.

Cut-Out Pressure: When an air compressor is turned on and begins to run, air pressure in the air tank begins to build. It builds to a certain high pressure before the motor automatically shuts off, protecting your air tank from pressure higher than its capacity. The high pressure at which the motor shuts off is called "cut- out" pressure.

Branch Circuit: Circuit carrying electricity from electrical panel to outlet.

1000002853 8 - ENG