ATTACHING THE LEGS TO THE BASE
Use a
Slowly and carefully, lower the saw/base assembly to the floor.
Fig. 4A
A
B
C
D
Fig. 4B
ATTACHING THE OVERARM ELEVATING HANDLE
1.Insert the shear pin (A) Fig. 5 into the hole in the elevating shaft (B). Use a hammer to tap this pin in place (Fig. 5).
2.Align the slots in the elevating handle (C) Fig. 5 with the shear pin (A). Place the handle on the shaft (B) making certain that the roll pin is engage in the slots.
3.Fasten the elevating handle (C) Fig. 5 to the shaft (B) with a
A
C 
B
D 
Fig. 5
Fig. 6
ATTACHING THE CUTTINGHEAD TO THE TRACK ARM
1.Raise the track arm assembly (A) Fig. 7 by turning the overarm elevating handle (D).
2.Remove the packing material from around the cuttinghead assembly (B) Fig. 7.
3.Push track arm clamp lever (C) Fig. 7 to the rear until it rests against stop (D).
4.Pull out on track arm index knob (E) Fig. 7.
A
C 
D
B
E 
F
Fig.7
9