ATTACHING THE TABLE BOARDS
1.Place the main table board (A) Fig. 26 on the table mounting brackets. Fit the the two roll pins in the table mounting brackets into the two holes in the bottom of the main table board (A). Fasten the table in place, Place a 1/4" flat washer on each of the
2.Place the remaining loose boards (C) Fig. 27 and fence (D) on the table mounting brackets, and tighten the two table clamp rod knobs (E). You can reposition the fence (D) as required.
B |
A |
Fig. 26 |
| C |
D |
|
Fig. 27 | E |
|
ATTACHING THE SAW BLADE AND BLADE GUARD
Use only 12” blades rated for at least 3450 rpm.
Disconnect the machine from the power source!
IMPORTANT: The blade guard should be in place for all cuts.
Before connecting the saw to the power source or operating the saw, always inspect the guard and splitter for proper alignment and clearance with saw blade. Check alignment after each change of bevel angle.
1.Remove the arbor nut (A) Fig. 28 and the outside blade flange (B).
2.Attach the saw blade (D) Fig. 29 between the two blade flanges (B) and (C) Fig. 28. Make sure that the teeth of the saw blade are pointing down (Fig. 29).
3.Place the arbor nut (A) Fig. 29 on the shaft. Tighten the arbor nut with the wrench (E) Fig. 29, while keeping arbor shaft from turning with the other wrench (F).
C
B
A 
Fig. 28
D
A
F 
B
L
A
D
E
T
E
E
T
H
5.
E
Fig. 29
14