English
•Avoid prolonged contact with dust from power sanding, sawing, grinding, drilling, and other construction activities. Wear protective clothing and wash exposed areas with soap and water. Allowing dust to get into your mouth, eyes, or lay on the skin may promote absorption of harmful chemicals.
WARNING: Use of this tool can generate and/or disburse dust, which may cause serious and permanent respiratory or other injury. Always use NIOSH/OSHA approved respiratory protection appropriate for the dust exposure. Direct particles away from face and body.
• The label on your tool may include the following symbols. The
symbols and their definitions are as follows: |
| ||||||||
V | volts | A | amperes | ||||||
Hz | hertz | W | watts | ||||||
min | minutes |
|
|
| .......... | alternating current | |||
|
|
|
| ..... direct current |
|
|
|
| alternating or direct |
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
| .......... | ||
|
|
|
|
|
|
|
| ||
|
|
|
| Class I Construction | no | current | |||
|
|
|
| ||||||
|
| .......... | |||||||
.............. |
|
|
| (grounded) | no load speed | ||||
|
|
|
| Class II Construction |
|
|
|
| earthing terminal |
|
|
|
|
|
|
|
| ||
|
| .......... |
|
| ............ | ||||
.............. |
|
|
| (double insulated) |
|
|
| ........... | safety alert symbol |
BPM | ...... beats per minute | …/min | per minute | ||||||
RPM | ...... revolutions per minute |
|
|
|
|
| |||
SAVE THESE INSTRUCTIONS
Motor
Be sure your power supply agrees with nameplate marking. As little as 10% lower voltage can cause loss of power and can result in overheating. All DEWALT tools are
WARNING: Accessories must be rated for at least the speed recommended on the tool warning label. Accessories running over rated speed can fly apart and cause injury. Accessory ratings must always be above tool speed as shown on tool nameplate.
CAUTION: Avoid contact with the blade teeth to prevent personal injury.
COMPONENTS (Fig. 1–3, 8)
WARNING: Never modify the power tool or any part of it. Damage or personal injury could result.
A. Plunge trigger | O. Outer flange |
B. On/off switch | P. Inner flange |
C. Main handle | Q. Riving knife |
D. Shoe | R. Riving knife adjustment screws |
E. Bevel adjustment knob | S. Speed wheel |
F. Depth adjustment knobs | T. Cutting indicator |
G. Depth scale | U. |
H. Front handle | V. Outer guard |
I. Dust extraction outlet | W. Track |
J. Track adjuster | X. Bevel scale |
K. Blade | Y. Blade position indicators |
L. Lock button | Z. Hex wrench |
M. Lock lever |
|
N. Blade clamping screw |
|
6