Delta 18-900L Attaching the Pinion Shaft Handles, Attaching LED Work Light, Chuck KEY Storage

ATTACHING THE PINION SHAFT HANDLES
To reduce the risk of injury, turn unit off	AA
and disconnect it from power source before installing
and removing accessories, before adjusting or when
making repairs. An accidental start-up can cause injury.
Thread the three pinion shaft handles (AA) in the three
holes located in the pinion shaft hub (BB) Fig. 14.
	BB	AA
ATTACHING THE		Fig. 14
LED WORK LIGHT
To reduce the risk of injury, turn	DD
unit off and disconnect it from power source		CC
before installing and removing accessories,	CC
before adjusting or when making repairs. An
accidental start-up can cause injury.

The included LED work light is to be attached to
the side of the headstock at wire (CC) Fig. 15.						EE
NOTE: Prior to connection, be careful not to
push wire (CC) into headstock as it is difficult to	Fig. 15			Fig. 16
retrieve.
1. Remove three 6 mm screws (one shown at
DD) Fig. 15.		DD
					FF
2. Connect the two wires — (CC) from the
			FF
headstock and (EE) from the LED worklight

— as shown in Fig. 16.

3.Remove plastic cable tie.

4.Push excess wire into the headstock.

5. Attach the LED work light (FF) Fig. 17 to
	Fig. 17	Fig. 18
the headstock using three screws removed
earlier. One is shown at (DD).

6.Final assembly of LED worklight (FF) looks like Figure 18.

GG

CHUCK KEY STORAGE

Storage for your included chuck key (GG) is built into the right side of the drill press head stock. Press chuck key into the holder as shown in Figure 19.

Fig. 19

T-SLOTS

The drill press table is fitted with two T-slots (HH) Fig. 20 for use with various drill press accessories (stop blocks, fences, or clamps). Use 5/16" T-bolts or 1/4-20 hex head bolts when attaching your accessory to the table.

Since accessories other than those offered by DELTA have not been tested with this product, use of such accessories could be hazardous. For safest operation, only DELTA recommended accessories should be used with this product.

HH

Fig. 20

11