DeWalt JT360 Infeed Table Adjustment Handle, Dust Chute Cover, Dust Collector Adapter

INFEED TABLE ADJUSTMENT HANDLE

1.Turn locknut (C) Fig. 12, clockwise on infeed table adjustment handle (B) as far as it will go.

2.Thread handle (B) Fig. 12, into block (D) which is located below infeed table (E).

3.Turn locknut (C) Fig. 13 clockwise to tighten against block (D).

Fig. 12 E

C

D

B

Fig. 13

C

D

DUST CHUTE COVER

1.Assemble dust chute cover (A) Fig. 14, to dust chute

(B)using two wing screws (C). IMPORTANT: Top of dust chute cover (A) must be inside top brace (D) of stand.

During operation, the dust chute cover

Fig. 14

D

A

(A)must always be assembled as shown and should only be removed for cleaning.

DUST COLLECTOR ADAPTER

C

B

A

C

If the machine is to be connected to a dust collection system, a dust collector adapter with a 4" O.D. opening is supplied with the jointer. To assemble the adapter:

1.Remove two wing screws (C) Fig. 14, from dust chute cover (A).

2.Assemble adapter (E) Fig. 15, over dust chute (A). Align two holes in dust chute (A) with holes in adapter

(E) and fasten with two wing screws (C) which were removed in STEP 1.

C

C

Fig. 15

E

12 - English