FENCE
1.Insert hexagon rod (A) Fig. 20, of fence assembly into bracket (B) on jointer as shown.
Fig. 20
B
A
2.Remove the M8x1.25x12mm long screw (D) and M8.4 flat washer (E) from the end of hexagon rod. Assemble rear cutterhead guard (C) Fig. 21, to end of hexagon rod using the M8x1.25x12mm long screw
(D) and M8.4 flat washer (E).
3.Thread fence locking handle assembly (F) Fig. 22, and M8.4 flat washer (G) into hole (Z) Fig. 21. Lock handle
(F)Fig. 22, is spring-loaded and can be repositioned by pulling out the handle and repositioning it onto the serrated nut located under the handle.
4.Thread fence tilting handle (H) Fig. 22, to threaded hole in back of fence as shown.
Fig. 21
Z
C
E
D
Fig. 22
H
F
G
CUTTERHEAD GUARD
1.Remove set screw (A) Fig. 23, from post (B) of cutterhead guard (C).
2.Assemble cutterhead guard (C) Fig. 23, to the jointer by inserting post (B) down through the hole in the infeed table. NOTE: A spring is supplied in knob assembly (D) that returns the guard (C) over the cutterhead after a cut has been made. Turn knob
(D)to tension spring before inserting post (B). Make certain the spring engages in the slot of the post. To adjust spring tension, remove the cutterhead guard (C) Fig. 23, and rotate knob (D) to the desired amount of tension. NOTE: THE CUTTERHEAD
GUARD MUST BE TENSIONED SO THAT IT WILL RETURN TO COVER THE CUTTERHEAD ONCE THE MATERIAL HAS PASSED.
Fig. 23
C
B
A
D