Logging On and Logging Off
Your controller may be set up to require a password for any operation (other than reviewing station and pump status, silencing alarms, reviewing the alarm log, and looking at help screens). If so, a keypad appears when you touch a button for a screen that requires a password:
•Enter the
Each digit appears as an “X” as you touch it. When you touch the fourth digit, the controller carries out your request. For example, it enables or disables the requested pump or station, or it goes to the Station n Operator screen. If you did not enter the correct password, the controller erases the entry. You can then try again. To give up, touch Return.
Note: If you have lost the password(s), contact the manufacturer for assistance.
Once you have logged on, the password remains active until you log off or the password expires. (Setup personnel at your facility control the number of minutes before the password expires.) While the password is active, you can continue to carry out
When you have finished any tasks that require the password, you should log off. (If you forget to do this, the controller will log you off when the password expires.) To log off:
1.Go to a Station Operator screen.
To reach this screen, go to the Station Summary if needed by touching Stations at any screen. Then touch and hold the icon for any station until its Station Operator screen appears.
2.Touch Log Off Operator near the lower right of the screen. The Station Summary screen appears.
7/50D Plus or 7/50D Controller | Chapter 4: Operation | 59 |