Hitachi C 10FCB Practical Applications, Stopper Optional accessory for precision cutting

English

7. Stopper (Optional accessory) for precision cutting

Workpiece		The stopper facilitates continuous precision cutting in lengths of
	Stopper	10" to 16-1/2" (255 mm to 420 mm). To install the stopper, attach it
		to the holder with the 6 mm wing bolt as shown in Fig. 13.

6 mm Wing Bolt

Fig. 13

PRACTICAL APPLICATIONS

WARNING: * To avoid personal injury, never remove or place a workpiece on the table while the tool is being operated.

*Never place your limbs inside of the line next to warning sign while the tool is being operated. This may cause hazardous conditions (see Fig. 14).

Line Warning Sign Warning Sign Line

1. Switch operation

Hole

Lock-off

Button

Handle

Trigger Switch

Fig. 14

The trigger switch lock-off button is designed to prevent inadvertent operation of the power tool. To operate the power tool, it is necessary to first fully insert the lock-off button into the hole on the handle as shown in Fig. 15.

The trigger switch will not operate unless the lock-off button has been pushed in.

When the trigger switch is released, the power goes off and the lock-off button automatically returns to its initial position, locking the trigger switch.

Fig. 15

WARNING: Always remove the lock-off button from the handle when the power tool is not in use. This will ensure that the power tool cannot be turned on accidentally or by someone (especially a child) who is not qualified to use the power tool. If the lock-off button is left in the handle, serious personal injury can result. Since the lock-off button fits rather tightly, it may be necessary to turn it to the left and right during mounting and removing.

14