English
4. Miter cutting procedures
| Side |
| Handle |
| Tighten |
| Loosen |
Miter Angle Indicator | Turn the |
Scale | Turn Table |
Fig. 18
(1)Loosen the side handle.
(2)Adjust the table until the indicator aligns with the desired setting on the miter angle scale as shown in Fig. 18.
(3)
CAUTION: Never remove the side handle; use of the tool without it would be hazardous. To prevent an accident or personal injury always firmly tighten the miter handle.
NOTE: * Positive stops are provided at the right and left of the 0° center setting, at 15°, 22.5°, 31.6°, 35.3°, 45° and 60° right and 15°, 22.5°, 31.6°,35.3° and 45° left settings.
Check that the miter angle scale and the tip of the indicator are properly aligned.
*Operation of the power tool with the miter angle scale and indicator out of alignment, or with the miter handle not properly tightened, will result in poor cutting precision.
5. Bevel cutting procedures
Indicator
Bevel Angle
Scale
Clamp
Lever
(1)Loosen the clamp lever and bevel the saw blade to the left.
(2)Adjust the bevel angle to the desired setting while watching the bevel angle scale and indicator, then secure the clamp lever (Fig. 19).
Fig. 19
WARNING: When the workpiece is secured on the left side of the blade, the short
If the handle is raised while the saw blade is still rotating, the
6. Compound cutting procedures
For compound cutting, follow the instructions in paragraphs 4 and 5 above. At a bevel angle of 45° and a miter angle of 45°, a workpiece of
CAUTION: Always secure the workpiece with the right hand side for compound cutting. Never rotate the table to the right for compound cutting, because the saw blade might then contact the clamp or vise that secures the workpiece, and cause personal injury or damage.
16