English
2. Inspecting the carbon brushes (Fig. 29 and Fig. 30)
The carbon brushes in the motor are expendable parts.
If the carbon brushes become excessively worn, motor trouble might occur.
Therefore, inspect the carbon brushes periodically and replace them when they have become worn to the wear limit line as shown in Fig. 29.
Also, keep the carbon brushes clean so that they will slide smoothly within the brush holders.
The carbon brushes can easily be removed after removal of the brush caps (see Fig. 30) with a slotted (minus) screwdriver.
Wear Limit Line
Brush Cap
44
1/4" (6 mm) No. 44 indicates the last two numbers of carbon
brush Code No.
5/8" (16 mm)
Fig. 29 | Fig. 30 |
3. Inspecting the mounting screws
Regularly inspect each component of the power tool for looseness.
WARNING: To prevent personal injury, never operate the power tool if any components are loose.
4. Inspecting the safety cover for proper operation
Before each use of the tool, test the safety cover (see Fig. 6) to assure that they are in good condition and that they move smoothly.
Never use the tool unless the safety cover operate properly and unless they are in good mechanical condition.
5. Storage
After operation of the tool has been completed, check that the following has been performed:
(1)Trigger switch is in OFF position,
(2)Power plug has been removed from the receptacle,
(3)Stored in a secure place.
When the tool is not in use, keep it stored in a dry place out of the reach of children.
6. Lubrication
Lubricate the following sliding surfaces once a month to keep the power tool in good operating condition for a long time (see Fig. 1 and Fig. 2). Use of machine oil is recommended.
Oil supply points:
*Rotary portion of hinge
*Rotary portion of vise assembly
*Rotary portion of sub fence
7. Cleaning
Periodically remove chips, dust and other waste material from the surface of the power tool, especially from the inside of the safety cover with a damp, soapy cloth. To avoid a malfunction of the motor, protect it from contact with oil or water.
20