Nilfisk-Advance America SR 1800S 2WD Using the Left Side Broom Optional, CAB Manual Lifting

USER MANUAL

ENGLISH

To empty the hopper (2, Fig. F) perform the following procedure:

11.Lift and turn off the side broom by pushing and holding the centre distributor lever (3, Fig. B-C).

12.Lift and turn off the main broom by shifting and holding the distributor lever (4, Fig. B-C) to the right.

13.Turn off the suction fan (25, Fig. F) by turning the distributor lever (18, Fig. B - 30 Fig. C) downward.

14.Close the skirt (19, Fig. F) by pulling and holding the left distributor lever (1, Fig. B-C).

15.Drive the machine on a solid and level area, appointed to empty the hopper.

16.Lift the hopper (2, Fig. F) as necessary, by pushing and holding the right distributor lever (12, Fig. B - 31, Fig. C).

CAUTION!

The maximum hopper dumping height is 1,460 mm.

WARNING!

Pay careful attention when the hopper is lifted. Avoid emptying it on slopes.

WARNING!

When emptying the hopper, check that there are no people around the machine.

17.Open the skirt (19, Fig. F) to discharge the debris, by pushing and holding the left distributor lever (1, Fig. B-C).

18.After emptying the hopper, close the skirt (19, Fig. F) by pulling and holding the left distributor lever (1, Fig. B-C).

19.Lower the hopper by pulling and holding the right distributor lever (12, Fig. B - 31, Fig. C).

20.Turn on the fi lter shaker (52, Fig. E), to clean the closed pocket fi lter, by pressing the push-button (15, Fig. B-C) for 15-20 seconds.

WARNING!

Do not turn on the filter shaker when the hopper is lifted.

1.Perform steps 8 to 12 in transport mode section.

USING THE LEFT SIDE BROOM (OPTIONAL)

1.See Using The Machine paragraph, working mode section.

USING THE WINDSCREEN WIPER/WASHER (OPTIONAL)

1.Press the switch (1, Fig. I) to start and stop the windscreen wiper.

USING THE CAB CLIMATE CONTROL SYSTEM (OPTIONAL)

1.To turn on the climate control system, turn the switch (18, Fig. C) to the fi rst position, which activates the fi rst blower speed.

2.To activate the second blower speed, turn the switch (18, Fig. C) to the second position.

3.To turn off the climate control system, turn the switch (18, Fig. C) to the original position.

LIGHTING SYSTEM OPERATION

1.To turn on the lighting and signalling system, use the combination switch (19, Fig. C), having the functions shown in Machine Description chapter, in Description of Control Panel with Options.

HAZARD WARNING LIGHT OPERATION

1.Turn on the hazard warning lights with the switch (22, Fig. C).

CAB MANUAL LIFTING

To lift/lower the cab manually, perform the following procedure.

1.Turn off the engine, by turning the ignition key (17, Fig. B-C) counterclockwise, to the end of stroke, then remove it.

2.Engage the parking brake (21, Fig. B-C).

3.Open the driver's seat hood (8, Fig. F).

4.Remove the hand pump lever (53, Fig. E).

5.Install the lever (53, Fig. E) on the hand pump (47).

6.To lift the cab, turn the pump selector (54, Fig. E) to the right. Pump by using the above-mentioned lever.

7.To lower the cab, turn the pump selector (54, Fig. E) to the left and pump until the cab is completely lowered.

8.Turn the selector (54, Fig. E) to neutral position.

SR 1800S D 2WD

33014097(2)2006-12 A

15