ENGLISH
USER MANUAL
Maintenance
Fuel fi lter replacement
Nut and screw tightening and leakage check
Lubrication
Engine coolant line sleeve check
Drive system pump oil fi lter check
Hydraulic system oil suction fi lter replacement
Alternator belt replacement Cab air fi lter replacement Injector calibration and cleaning
Climate control system belt replacement
Engine coolant replacement Hydraulic system oil change Brake system check
Hydraulic system pump pressure check
Minor engine overhaul
Major engine overhaul
Every 10 hours | Every | Every | Every | Every | Long | ||
(after the first 24 | 200 | 600 | 1,200 | 2,400 | |||
or before use | periods | ||||||
hours) | hours | hours | hours | hours | |||
|
| ||||||
|
| (7) |
|
|
|
| |
(6) |
| (6) |
|
|
|
| |
|
| (6) |
|
|
|
| |
|
| (7)(6) |
|
|
|
| |
(6) |
| (6) |
|
|
|
| |
(6) |
| (6) |
|
|
|
|
(3)(6)
(1)
(2)(3)(6)
(6)
(3)(6)
(3)(6)
(6)
(6)
(2)(4)(6)
(2)(5)(6)
(1): Or every 6 months
(2): Maintenance to be performed by Lombardini authorised Service Center
(3): Or every 2 years
(4): After 5,000 hours
(5): After 10,000 hours
(6): For the relevant procedure see the Service Manual, at any Nilfi
(7): Every year, if the machine is not frequently used.
(8): If a
HOPPER CLEANING
WARNING!
Protect body parts (eyes, hair, hands, etc.) properly, when performing cleaning procedures using compressed air or water gun.
Empty the hopper (2, Fig. F), drive the machine to the appointed cleaning/washing area, then perform the following procedure:
1.Engage the parking brake (21, Fig.
2.Lift the hopper (2, Fig. F), according to the procedure shown in the relevant paragraph.
3.Open the skirt (19, Fig. F).
4.Install the support rods (4, Fig. F).
5.Clean the hopper with pressurized water.
CAUTION!
With pressurized water clean the skirt and the lower part of the hopper only, to avoid dampening the closed pocket filter (26, Fig. E).
18
SR 1800S D 2WD