ENGLISH
USER MANUAL
HOPPER SUPPORT ROD INSTALLATION
1.When it is required to work under the hopper, lift it completely by pushing and holding the distributor lever (12, Fig. B - 31, Fig. C), then install the support rods (4, Fig. F).
AFTER USING THE MACHINE
When the working cycle is completed, the machine must be stored as follows:
1.The main broom must be lifted (see Using The Machine paragraph).
2.The side broom must be lifted (see Using The Machine paragraph).
3.The suction fan must be turned off (see Using The Machine paragraph).
4.The throttle lever must be turned to “MIN”.
5.The hopper must be lowered (see Using The Machine paragraph).
6.The engine must be off (see Diesel Engine Start and Stop paragraph).
7.The headlights must be turned off.
8.The parking brake must be engaged.
TOWING THE MACHINE
To tow the machine, proceed as follows.
1.If possible, empty the hopper (2, Fig. F). If the hopper contains a small quantity of waste, it is not necessary to empty it.
2.Engage the parking brake (21, Fig.
3.Turn off the engine, by turning the ignition key (17, Fig.
4.Open the engine hood (5, Fig. F) and fasten it with the support rod (6, Fig. F).
5.Loosen the
6.Tow the machine by fastening it on the appointed anchors, which are marked by appropriate labels (55, 56, Fig. F - 57, Fig. E).
TRANSPORTING BY TRAILER
To transport the machine by trailer, use the anchors and follow the procedures shown below.
WARNING!
Machine anchorage must be performed by qualified personnel.
Available anchors
1.The machine is equipped with the following anchors:
– No. 2 side anchors (55, Fig. F)
– No. 2 rear anchors (56, Fig. F)
NOTE
The anchors are marked by appropriate labels.
Anchorage
2.To anchor the machine in case of transport by trailer, proceed as follows:
•Set the machine to transport mode (see the procedure in the relevant paragraph).
•Remove the ignition key (17, Fig.
•Engage the parking brake (21, Fig.
•Close all lids, hoods, etc.
•Fasten the machine on the appointed anchors (55, 56, Fig. F) with suitable bands.
MACHINE STORAGE
If the machine is not going to be used for more than 30 days, proceed as follows:
1.Prepare the machine, as shown in After Using the Machine paragraph.
2.Store the machine indoor, in a clean and dry place, protected from bad weather conditions and with the following values:
•Temperature: +1°C to +50°C
•Humidity: maximum 95%
1.Disconnect the negative connector from the battery (43, Fig. F).
2.Handle the diesel engine as shown in the relevant Manual.
FIRST PERIOD OF USE
After the fi rst period of use (fi rst 8 hours) it is necessary to perform the following procedures:
1.Check the fastening and connecting elements for proper tightening. Check the visible parts for integrity and leaks.
2.After the fi rst 50 working hours, perform checks and replacements shown in the Scheduled Maintenance Table.
16
SR 1800S D 2WD