Wayne-Dalton 9800 Series Drum Wrap Installation, Rear Support, Keep horizontal track, Death

32

Tools Needed:

None

	Drum
Drum Wrap Installation	Wrap
Drum wraps are identified as right and
left hand.	Outside
To install, place the right hand drum	Flange
wrap over the cable drum and under
the idrive® disconnect cable. Align the
outside flange over the outside edge of
the cable drum and push the drum	Cable
wrap down onto the cable drum. Repeat	Drum
for left hand side.
NOTE: Drum wraps must be installed to
prevent cable from becoming tangled.
	Drum
IMPORTANT: Right and Left hand	Wrap
is always determined from inside
the GARAGE looking out.
	Cable
	Drum

INSTALLATION

33	Rear Support	DOOR IN THE
Tools Needed:	WARNING	UP POSITION
Ratchet Wrench	Keep horizontal track
1/2” Socket	parallel and within 3/4”
	maximum of door edge,
1/2” Wrench	otherwise door could fall,
	resulting in severe injury or
(2) Vice Clamps	death.
Level	Raise the door until the top section and
	half of the next section are in a horizontal
Hammer	position. Do not raise door any further
	since the horizontal track are not yet
		3/4”
Tape Measure	supported at the rear.		vice
	WARNING	Door Edge
			clamps
	Raising door further can
	result in door falling and
	cause severe injury or death.
	Clamp a pair of vice clamps on the vertical		vertical
	tracks just above the second roller on one
			TRACK
	side, just below the second roller on the
	other side. This will prevent the door from	Horizontal Track
	raising or lowering while installing the rear
	support. Using perforated angle, 5/16” x
	1-5/8”hex head lag screws and 5/16” bolts
	with nuts (may not be supplied), fabricate
	rear support for horizontal tracks.

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local 33 yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com