Wayne-Dalton 9800 Series installation instructions This step, Hex nuts

14		Attaching Horizontal Track to
		Adjustable Flagangle
	NOTE: If quick install flagangles were
Tools Needed:
9/16” Socket	installed in Step 13, skip this step and
	continue with Step 15. If not, complete
7/16” Socket
	this step.
Ratchet Wrench	To install horizontal track, place the
9/16” Wrench
	curved end over the top roller. Align
Level
	the bottom of the horizontal track with
Flat tip
	the vertical track. Hand tighten the
Screwdriver	horizontal track to the flagangle with
	(1) stud plate and (2) 1/4” - 20 flange
	hex nuts.
		WARNING
	DO NOT RAISE DOOR UNTIL
	HORIZONTAL TRACKS ARE SECURED­
	AT REAR, AS OUTLINED IN STEP 33, OR
	DOOR COULD FALL FROM OVERHEAD
	POSITION­ CAUSING SEVERE OR FATAL
	INJURY.
	Level the horizontal track assembly and
	bolt the horizontal angle to the slot in
	the flagangle using (1) 3/8” - 16 x 3/4”
	truss head bolt and (1) 3/8” - 16 hex
	nut. Repeat for other side. Remove the
	nail that was temporarily holding the
	top section in place, installed in Step
	12.
	IMPORTANT: Failure to remove nail
	before attempting to raise door
	could cause permanent damage
	to top section.
	NOTE: If an idrive® opener will be
	installed, position horizontal tracks
	slightly above level.

Flagangle	Stud
	plate
1/4” - 20
flange hex
nuts
	INSTALLATION
flagangle
3/8” - 16 X 3/4”	3/8” - 16 Hex nut
TRUSS HEAD BOLT
	hORIZONTAL ANGLE
	HORIZONTAL
	TRACK

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local 21 yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com