Wayne-Dalton 9800 Series installation instructions Cable Adjustments, Tools Needed Vice Clamp

28

Tools Needed:

Vice Clamp

Securing Door

for Spring Winding

WARNING

Failure to place vice clamps onto vertical Track can allow door to raise and cause severe or fatal injury.

Place vice clamps onto both vertical tracks just above the third roller. This is to prevent the garage door from raising while winding counterbalance springs.

IMPORTANT: DO NOT USE IMPACT GUN TO WIND SPRING(S).

place vice

clamps above

3rd Roller

vice clamps	Track
attached to
inner rail
of track

INSTALLATION

29

Tools Needed:

Locking Pliers

Flat Tip

Screwdriver

Cable Adjustments

Rotate the cable drum until the set screw faces directly away from the header. TorqueMaster® Spring Tube cam peak should be pointing straight up.

Beginning with the right side, loosen the set screw enough to adjust cable, approximately 2 turns. Using locking pliers, pull on the end of the cable to remove all cable slack.

Check to ensure the cable is aligned and seated in the first groove of the cable drum. Snug the set screw, then tighten an additional 1-1/2 turns. Cut excess cable.

Counterbalance

Cable

Cable

Drum

Cam Peak

Straight Up

Set Screw

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local 31 yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com