Wayne-Dalton 9800 Series installation instructions Operator Bracket

11	Operator Bracket
	NOTE: If installing a trolley type
Tools Needed:
Power Drill	operator, complete this step. If not, skip
	this step and continue with step 12.
7/16” Socket
Driver	IMPORTANT: When installing a
	trolley type operator on 9800
	door, a Wayne-Dalton trolley
	bracket must be securely
	attached to the top section. It
	is then unnecessary to further
	reinforce the top section of
	the model 9800 Wayne-Dalton
	door, when attaching a trolley
	type operator, as long as the
	installation of the operator
	is according to Installation
	instructions and owner’s manual
	and force settings are adjusted
	properly.
	Remove, but retain (4-6) 1/4”-20 x 7/8”
	self drilling screws from the center of
	the u-bar, allowing the operator bracket
	to slide between the section and the
	u-bar.
	NOTE: For retro fit applications, the
	operator bracket must be aligned with
	an existing operator
	Locate the center of the top section and
	slide operator bracket under u-bar till
	the operator bracket is seated against
	the u-bar flange.
	NOTE: Prior to fastening operator
	bracket to top section, ensure the top
	edge of operator bracket is aligned with
	the top edge of the section as shown on
	far right.
	Attach the operator bracket using (6)
	1/4” – 20 x 5/8” self drilling screws (as
	shown). Finish re-attaching the u-bar
	using the self tapping screws removed
	previously.

u-bar

Side view of u-bar

1/4”-20 X 7/8” self

DRILLING screws

Operator

bracket

U-bar

Top of section

Top edge of

operator

bracket

U-bar

U-bar

Operator

bracket

Operator

bracket

Side view of u-bar with

Operator bracket installed

( 6) 1/4”-20 X 5/8”

self drilling

screws

Operator bracket in

place under u-bar

18Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local

yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com