Wayne-Dalton 9800 Series installation instructions Pull Rope, Tools Needed Power Drill Drill Bit

Page 36

Tools Needed:

Power Drill

1/8” Drill Bit

Pull Rope

WARNING

DO NOT INSTALL PULL ROPES ON DOORS WITH ELECTRIC OPERATORS. CHILDREN MAY BECOME ENTANGLED IN THE ROPE CAUSING SEVERE OR FATAL INJURY.

Measure and mark the jamb approximately 48” to 50” (1220 to 1270

mm)from floor on the right or left side of jamb. Drill 1/8” pilot hole for No. 6 screw eye. Tie the pull rope to the No. 6 screw eye and to the bottom bracket as shown.

NO. 6 SCEW EYE

PULL ROPE

BOTTOM BRACKET

PULL ROPE

36Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts

You May Need.You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.Wayne-Dalton.com

Image 36

Contents Series 4 Section Important NoticeTable of Contents Package Contents PRE-INSTALLATIONDoor Section Identification Power Drill Tools Required3/16 Drill Bits GlovesTorsion Spring Removal For Standard Lift Failure to use approvedWinding bars can cause spring Energy to be released Suddenly, resulting in severe Or fatal injuryUnwind Springs TorqueMaster Spring RemovalBracket and Drive Gear Extension Spring Removal Removing the Old DoorPreparing the Opening Installation Attaching Quick Install Flag Angle to Vertical TrackTools Needed None FlagangleBe installed as shown Horizontal AngleTap the horizontal angle towards AsideBrackets Installing Q.I. Jamb Brackets Bottom Section Vertical TrackStacking Sections Top Brackets With the second set of holes fromEndcap 20 x 5/8 carriage boltsOperator Bracket Top Section Attaching Horizontal Track to Do not Raise Door UntilInjury This step Hex nutsAdjusting Top Brackets Must install the center bracket bushing TorqueMaster Spring TubeCenter Bracket Bushing Continue with Step Idrive opener on your garage door, youIdrive Installation Cable Drum Installation Drive Gear Installation End BracketsTools Needed Lubricating Oil Repeat for left hand side.`Counter Installation Securing Center Bracket AssemblyInstallations on page 35, Figure B Repeat for left hand side for double spring applicationsPositioning Support Bracket Attaching Disconnect Cables Mounting DisconnectHandle Bracket Disconnect handle. Thread Disconnect handleBracket Secure disconnect cable toCable Adjustments Tools Needed Vice ClampTools Needed Locking Pliers Flat Tip Screwdriver Important do not USE Impact GUN to Wind SpringsSetting Spring Tension Winding Bolt RotationRecommended Spring Turns Drum Wrap Installation Rear SupportKeep horizontal track Parallel and within 3/4 Maximum of door edgeAdjust weather seal or door stop if Attach horizontal tracks to the rearTools Needed Weather seal or door stop to both doorSide Lock DoorMaster TM BracketTools Needed Power Drill Drill Bit Pull RopeNo Scew EYE Pull Rope Bottom Bracket Trolley Operator Operator Must be Tested AT TimeResult in Severe or Fatal Injury Door is fully open trolley rail willCleaning Your Steel And Fiberglass Garage Door Glass Cleaning InstructionsAcrylic Cleaning Instructions Important do not USE a Pressure Washer on Garage DoorSteel Preparation For Painting Fiberglass Refinishing And Or FinishingLifetime Limited Warranty Model Thank you for your purchase