INSTALLATION STEP 7
Install the Light
•Install a 75 watt maximum light bulb in the socket. The light will turn ON and remain lit for approximately
•Apply slight pressure on the sides of the lens and slide the tabs into the slots in the end panel (See illustration).
•To remove, reverse the procedure. Use care to avoid snapping off lens tabs.
•If the bulb burns out prematurely due to vibration, replace with a Garage Door Opener bulb.
NOTE: Use only a standard light bulb. The use of a short neck or speciality light bulb may overheat the endpanel or light socket.
To prevent possible OVERHEATINGof the endpanel or light socket,
•DONOTuse short neck or specialty light bulbs.
•DONOTuse halogen bulbs. UseONLYincandescent.
Light
Lens
Guide
Lens
_"Slot
75 Watt (Max)
Standard
LensLight Bulb
Tab
INSTALLATION STEP 8
Attach the Emergency Release Rope and Handle
•Thread one end of the rope through the hole in the top of the red handle so "NOTICE" reads right side up as shown. Secure with an overhand knot at least 1" (2.5 cm) from the end of the rope to prevent slipping.
•Thread the other end of the rope through the hole in the release arm of the outer trolley.
•Adjust rope length so the handle is 6 feet (1.83 m) above the floor. Ensure that the rope and handle clear the tops of all vehicles to avoid entanglement. Secure with an overhand knot.
NOTE: If it is necessary to cut the rope, heat seal the cut end with a match or lighter to prevent unraveling.
To prevent possible SERIOUSINJURYor DEATHfrom a falling garage door:
•If possible, use emergency releasehandleto disengage trolley ONLYwhen garagedoor is CLOSED.Weak or broken springs or unbalanced door could result in an open door falling rapidly and/or unexpectedly.
•NEVERuse emergency releasehandle unless garage doorway is clear of persons and obstructions.
NEVERuse handle to pull door open or closed. If rope knot becomes untied, you could fall.
Trolley
Enlergency _ | _) KOnVe[band |
Release Handle | _, |
18