RECORDING
RECORDING
This section explains how to record from the radio or CD player.
Preparation
•Set the tape to the point where recording will start.
•Use Type I (normal) tapes only.
To record only the selected tracks
Select the tracks in the same procedure for programmed play (page 11), then start recording.
NOTE
If squealing or beating sounds occur when recording an AM broadcast, press the MODE button on the remote control, so as to eliminate the noise.
Each time the button is pressed, the dot light on the display is turned on and off.
Dot light
INSERTING BLANK SPACES
When recording from a radio broadcast,
1 Insert the tape to be recorded.
Insert the tape with the side to be recorded on facing up and the exposed side facing forward.
Insert with the recording side up.
2 Press the TAPE/REV MODE (TAPE) button to select the reverse mode.
To record on one side only, select P.
To record on both sides, select or ].
If the recording starts from the reverse side, recording
will be done on this side only even if or ] is selected.
3 Press one of the function buttons and prepare the source to be recorded.
To record from a CD, press the CD button and load the disc, then press the for g button to select the track to be recorded first.
To record from a radio broadcast, press the TUNER/ BAND button and tune in to a station.
4 Press the wREC/REC MUTE button to start recording.
REC on the display flashes.
When the selected function is CD, playback and recording start simultaneously.
NOTE
When operating with the remote control, press the
wREC/MUTE button for 1 second to start recording.
To stop recording, press the sbutton.
To pause recording, press the abutton. (Applicable when the source is RADIO.) To resume recording, press again.
NOTE
Blank spaces cannot freely be inserted when recording from a CD.
1Press the wREC/REC MUTE button during recording or while in recording pause mode.
The flashing REC on the display becomes quicker and the tape runs without recording (blank spaces are inserted).
After 4 seconds, the tape pauses (recording pause mode).
To make blank spaces less than 4 seconds, press the wREC/REC MUTE button again while REC flashes quickly.
To make blank spaces more than 4 seconds, press the wREC/REC MUTE button again after the deck enters the recording pause mode. Each time it is pressed, a 4- second blank space is added.
2Press the abutton to resume recording.
To erase a recording
1Press the TAPE/REV MODE button and insert the tape to be erased.
2Set the tape to the point where the erasure is to be started.
3Press the wREC/REC MUTE button to start the erasure.
Sound adjustment during recording
The output volume and tone of the speakers or headphones may be freely varied without affecting the level of the recording.
12 ENGLISH